Jump to content
SAU Community

Recommended Posts

  • 3 weeks later...
  • 1 month later...

Been following this thread on and off for years. And reading the chassis developments makes me feel alot. Sympathy that its happenex to a car youve put alot of time and effort into. Aswell as dread a Nd panic for my on gtr. Makes me want to run outside and check every inch of mine

  • 2 weeks later...

Been following this thread on and off for years. And reading the chassis developments makes me feel alot. Sympathy that its happenex to a car youve put alot of time and effort into. Aswell as dread a Nd panic for my on gtr. Makes me want to run outside and check every inch of mine

Well my case is quite bad to the point that I don't think its safe driving it - hence the decision to part with it. These are old cars now just gotta maintain them even more. Restorations and rebuilds are almost inevitable now if you want to keep the car in good nick.

ants - any tips on removing side skirts and not screwing up the clips, need to paint mine up

clips are easily replaceable and cheap as chips - I found that using WD40 on the adhesive made it loose without ruining the paint and use plastic scrapers. Just ensure you clean up the WD40 after you have removed the adhesive bond.

Yeah he is. He already started.

this is accurate

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Working through possible solutions of converting my mechanical speedo.    Anyone know what type of speedo sensor the factory r34 gtr getrag has ? what the output is ? I assume its not a VSS and more a voltage like earlier speedo sensors ? Can an ECU read it ?  
    • roof rail delete used to be a thing, they were made locally for a while too
    • I can get more photos of it here soon and I plan to make a thread detailing the process. I received the car this way and it sorely needs refinishing. That is probably the most appealing photo of it. Up close it is fading, cracked, and needs to be re-glued. Depending on their condition I'm on the fence between refinishing or making a new set.  Another angle hiding the pimples and razor pumps  
    • According to this thread the RS4V with build plate RC40 comes with the R200 diff @ 4.083 ratio as well (mine has said RC40 denotation). We may need to check if the axle stubs are the same pattern as well. The auto subframes have longer axles. However I think yours being a later Series 2 as well, we should have the same bolt pattern for the diff stubs. Unless your upgraded rear also has upgraded axles. Either way, I would not be opposed to pulling the covers to check so I can inspect that  fancy rear core  Also I don't have HICAS. I don't believe that should change things but I hope the people here with heaps more experience than me can correct me if I'm wrong   Let me know if you want to attempt to make this work and I can get some pictures of mine from under the car. 
    • It's not that straightforward. For example I have had this code because my ignitor/power transistor wires were unplugged. It knows something is wrong but has no idea what it means. If you want to actually diagnose this I recommend following the service manual flowchart for code 21. Ohm out the harness, coilpacks, inspect the ECU, etc. And again, it's entirely possible for there to be no problem at all but if you're running a different coilpack it'll trigger the code because it doesn't like what it sees.
×
×
  • Create New...