Jump to content
SAU Community

Recommended Posts

These are most the parts for sale Ill just add as I go :yes: Remade thread as old one was getting to big.

Under dash panel driver side with fuse box cover $20

Stock r32 side mount intercooler $50

A pillar trims $30 each or $50 for a pair

GTST air con condenser $70

2 x r32 hand brake and cable $70 each

GTR front strut brace $100

2 x pairs of r32 5 stud front hubs and up rights $100 a pair

Under dash panel with fuse box cover $20

4x lower quarter trims $30 each

Rubber gear box surround with metal ring $20

2xglove boxes

Under dash trim panel $15

R32 glove box $30

3 x speedo clusters 2 x grey, 1 x blue dials $80 each

3 x climate control unit $70 each

centre console dash panel radio surround $40

Upper rear trim driver side all clips still there cracked in corner otherwise good con $40

Rear bar $70

Rear reo $80

Tail lights $70

Steering Colum surround $50

Rear parcel shelf $50

Centre console ash tray $10

Window black box driver $50

Front bonnet latch and support $50

2xwiper motors $40 each

RB20 speedo cable $80

Nissan din pocket $20

Washer bottles rad overflow and washer $50 each

Non projector headlights $200

1 x passenger window switch $50

Air con box $50

Heater box $50

Passenger window reg $80

Passenger and driver kick panel $20 each

Boost sender/sensor R32 $20

Clutch pedal $80

Break pedal $40

Carbon canister $20

Boot lid $80

Bonnet latch and cable $40

Fuel/boot cable $50

2 x stock r32 steering wheels good condition one $70 little ratty $50

Surround ash tray $10

Mirrors $60 each

Front LCAs $120 a pair

Fuel pump $40

Dash all good vents $200

Door shells $100

2xcluster surrounds $20 with some cuts in them

Light switches/wiper switches $30 each

Carpet $100

Gear boot $10

Hand brake boot $10

Driver side dash vent $40

Sun visors $10 each

Rear view mirrors $20 each

Clutch master $30

Gear boot plastic surround $30

Indicators with wiring no outer covers $10

Wiper arms $10

Driver dash vent $40

Stereo brackets $20

R32 Mspec plastic bar $200

2x driver side window switches $70 each

Fuel tank $150-

gold coast and kilcoy

  • Replies 48
  • Created
  • Last Reply

Top Posters In This Topic

  • 3 weeks later...
  • 3 weeks later...
  • 2 weeks later...
  • 2 weeks later...
  • 3 weeks later...
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • If it (the code) wasn't still current, it should have gone away by itself by now. No, nothing it 10/10. But it is quite likely. Everything else to do with the ignition could still be responsible (which is wires and connectors). The car is an old piece of shit now, so all the wires and connectors are also old pieces of shit.
    • Lock me in mate, although I'm not sure if I'll be heading up from Goulburn or down from Sydney, either way, return will be back to Goulburn 
    • Sounds good, we will aim to be there! @The Bogan I'll give you a shout if you are heading up to campbelltown for the meet too.
    • Before I get to the test day, just to finish off the android head unit. This is a demo from car start up....the standard/host system takes a few seconds to boot (same as all v37) but Android comes up quickly. In this vid I'm using the delivered launcher but have set the default to Agami since which is easier to navigate when if use primarily 5 apps. You can see the host system still takes over when required eg putting it in reverse, and you can switch between Android and not by holding the back button 3 sec. It is pretty responsive (fast) but you can see I had to press harder than expected a couple of times.  I still have the phone connected to the stock system, and that also seamlessly takes over Android music playing. v37-android-demo.mp4 The bigger reason that I put this in though is so that I can use Ecutek directly on the head unit. That gives me a dash with logging (up to 20MB only), high and low value warnings on any parameter etc etc. I've run a USB cable from the Ecutek OBD dongle to a USB input on the unit, easy. v37-ecutek-demo.mp4   The unit did freeze on the launcher the other day, I think Agami was trying to verify the license when it didn't have a data connection...will monitor and report back if there are any other problems but so far I'm very happy with the upgrade.
    • Nah that is just crappy GPS mapping, I did have a small excursion (cold tyres, damp track, surprise!), will post up that when I get a chance.
×
×
  • Create New...