Jump to content
SAU Community

Recommended Posts

Hey all,

It's cold, and i'm tired, and i'm sick of working on my car atm. RB25DET NEO swapper R32 gts-t chassis.

Power windows, and the dash (tacho and fuel sender) is not working. Cannot find any wiring diagrams at all for the power windows, i looked through the R32 GTR complete service manual and i cannot find anything for the life of me. Doing shitloads of googling and it seems a few other people on here and GTROC etc etc are having the same issuse.

Power windows don't respond to any inputs and they are not getting any power to them.

Does anyone have any idea how they get power? It must be pulled from the same spot as the dash gets power from yeah? I will have a look at some wiring diagrams and try and chase it later. I'm just over it at the moment haha >_<

Also why is there not an electrical/wiring subforum?

Link to comment
https://www.sau.com.au/forums/topic/429559-r32-power-window-and-dash-problem/
Share on other sites

wiring/electrical issue problem resolution seem to be out of the reach of most on this forum hence why there is no subforum, time for you to see an electrician

Edited by StevenCJR31

Yeah i understand that wiring problems are especially hard to diagnose over the internet, but i bet a lot of the basic ones could get sorted and it would be a good place to put up a collection of wiring diagrams and conversion loom stuff.

Anyway i am thinking about just taking it to an auto-elec but i am hoping its something as simple as a relay not working or something getting a bad earth.

Does anyone have any idea what the 4 relays next to the fuse block under the steering wheel do?

Hey, I hit this problem in my RB25 conversion, buck gets ten you don't have brake lights or turn signals either. Its your main 75 amp fuse. Even if you didnt need one before, after the swap you do. All your accessories run off the 75 amp main. Try bridging it with some wire and see if your accessories come on.

My brake lights and indicators are both working fine mate. 75 amp fuse only has 1 ohm resistance so i dont think it will be that. But i will try bridging it and see what happens, open to any other ideas!

Should mention that everything else works, auto door locks, stereo, dash lights, high beam lights on dash, indicator lights on dash all work. No other lights (cat warning temp/check engine, handbrake etc) lights come on at all though :S

Hm, could be a difference in a NEO swap to my S1 swap, but all I know is my cluster and windows didn't work without a 75A Main. Was that the resistance your Fuse had? If so, I'd say it's good, yes.

  • 1 month later...

did you solve this problem? im having same problem everything works except windows and rev guage, i have a clicking relay under dash a round black 1 and the wires are getting hot my drivers windows works for 2 seconds then the round relay clicks aswel i replaced relay and still clicks. this started after i hooked battery up backwards must be a ground sumwhere i cant find i found 1 burnt out and replaced but must be another 1 sumwhere have ripped the whole dash and carpet out cant see anything think i might have to go to sparky

  • 1 month later...

i ended up tracing the clicking relay to the window amp in passenger door unplugged it fixed it all windows started working again and no clicking must have fryed rev gauge putting battery backwards got a new amp and my window started working again

  • 4 months later...
  • 4 months later...

Hey all

Im from Jamaica. hopefully this bit of info can help... will provide pics where i can

i just bought a R32 gtst..... previous person did some conversions and trust me, they really did a number on the wiring

since night me n my friend took it out for a drive... after really punching it i realized the cluster went dead, gauge controllers were dead, and powewr windows didnt work anymore..

i did some digging and realized that there was a bridged wire to the fuse box.... it was bridged to 10A meter fuse under the dash..

not sure what it was connected to but will check and let u guys know...

i literally just found out tonight and i found it quite shocking but will post soon..... im hoping i can really help

as i promised

but this is truly some really shabby wiring

last night my cluster went dead no spedo no nothing and also my boost gauges were dead and also power windows would work...

that yellow wire in the pic was the culprit(the one coming from the fuse box) ... im not sure what wire it is connected to there ut it seems to be factury wiring (blue with white or grey dots)

according to the fuse box label... the one its connected to is for the air conditioner (wrong size fuse there too)

so guys u know this car has to be really rewired... lol

post-135610-0-02223600-1405613618_thumb.jpg

post-135610-0-31471100-1405613620_thumb.jpg

Edited by skylinekid_9
  • 2 years later...

Sorry to drag up an old topic, but I'm having this issue as we speak and can't find the cause!  Speedo cluster is getting no ignition power, in turn the alternator will not charge, no power windows working. All other electrics work fine, car still runs ok. Would appreciate any help! Thanks

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
    • I've managed to find this: Nissan_Stagea_AutechVersion260RS (1).pdf
×
×
  • Create New...