Jump to content
SAU Community

I Wonder How Hard The Police Push These New Laws ?


Recommended Posts

.....not yet :/ lol.

Lol

Get it plumbed back lmao

They still scream with the right build and set up. Mines louder then my mates and he has a vented screamer while I'm plumb back

Lol

Get it plumbed back lmao

They still scream with the right build and set up. Mines louder then my mates and he has a vented screamer while I'm plumb back

I thought plumbing it back made it go away completely?

It's the only thing that gives me goosebumps, can't get over that sound of the wastegate screaming.. Even if it is the wank factor :P

I am getting it plumbed back.. But it's the only thing stopping me from driving so I thought I might as well take it back home and hopefully not get pulled over..

Iv recently changed my turbo & gone external gate. Its currently plumbed back & definitely doesn't scream. I do have a section of pipe I remove & then replace with another section of pipe that's modified so I can make it a screamer for track days. haven't tested how well it works yet though.

Maybe get something like that done?

  • Like 2

Iv recently changed my turbo & gone external gate. Its currently plumbed back & definitely doesn't scream. I do have a section of pipe I remove & then replace with another section of pipe that's modified so I can make it a screamer for track days. haven't tested how well it works yet though.

Maybe get something like that done?

Sorry forgot to mention you will need a titanium dump pipe off turbo with titanium waste gate pipe plumbed back for it to still scream like a screamer lol

Got a Gtr 33 V-spec with loudish aftermarket exhaust and tein coilovers fairly low. Thought cops would be my worst nightmare and dislike them with a passion , but surprisingly they have been very sedate towards me whilst passing me or me passing them. But in saying that you dont go out of your way to attract attention and I only just keep the accelerator pressed to avoid loud than average sound when in obvious view or hearing range! Wish everyone else the same luck!

Got a Gtr 33 V-spec with loudish aftermarket exhaust and tein coilovers fairly low. Thought cops would be my worst nightmare and dislike them with a passion , but surprisingly they have been very sedate towards me whilst passing me or me passing them. But in saying that you dont go out of your way to attract attention and I only just keep the accelerator pressed to avoid loud than average sound when in obvious view or hearing range! Wish everyone else the same luck!

Yours is purple as well from memory so it would stand out. Are you going to be able to make it to the charity cruise?

Got a Gtr 33 V-spec with loudish aftermarket exhaust and tein coilovers fairly low. Thought cops would be my worst nightmare and dislike them with a passion , but surprisingly they have been very sedate towards me whilst passing me or me passing them. But in saying that you dont go out of your way to attract attention and I only just keep the accelerator pressed to avoid loud than average sound when in obvious view or hearing range! Wish everyone else the same luck!

Man, if that was you the other week down at Miami. Awesome car!

I'm more curious as to how it will fair in court after the ruling handed down in Bell v Police ([2012] SASC 188)

Forfeiture overturned.

These type of laws clash with constitution. This is Sth Aus case where prosecution was beaten.

The laws are an affront to freedom of association on the bikie front in sa and qld and an interference with private property by the Crown - Both the fault of the executive (politicians) and laws that are unlikely ever to succeed for very good reasons when heard before the High Court.

Old 20-10-2012, 11:06 PM #47

NX74205

Regular Member

NX74205's Avatar

Join Date: Oct 2008

Location: Perth, WA

Posts: 417 Default Re: Anti Hoon Laws Unconstitutional

--------------------------------------------------------------------------------

There is a big, big difference between a 'privilege' and a 'right'. The ability to hold a driver's licence is a 'privilege'. The ownership of property is a right. I'm arguing for no more than the protection of the rights of all citizens and the basic jurisprudential principle of the rule of law.

By all means, take away a convicted hoon's privilege of being able to operate a vehicle on public roads, but their property rights are indissoluble and inviolable. Punishment is about the removal of privileges. It is not about arbitrarily removing the rights of others.

English jurist John Locke wrote in The Second Treatise of Government that "whenever the legislators endeavour to take away and destroy the property of the people ... they put themselves into a state of war with the people, who are thereupon absolved from any further obedience ..."

The confiscation of motor vehicles for hooning offences is not a just law, and natural law principles dictate that when a law is not a just law (i.e. not founded on moral justice), then it is no law at all.

__________________

Current car:

2005 Ford BF Fairmont, lightning strike (2006-present)

Previous cars:

1989 Ford EA Falcon GL, winter white (2000-2007)

1982 Ford KA Laser Ghia, blue (1999-2000)

QFT ^^

  • Like 2

Bikies today SAU members tomorrow. Read article to see how draconian legislation is attempted to be made:

http://www.skynews.com.au/topstories/article.aspx?id=926343&cid=BP_RSS_TOPSTORIES_3_LaborwalksoutonQldbikielawdebate_201113

Campbell Newman and ignorance of the constitution (the only document giving us any implied rights) seem to go hand in hand.

Forfeiture overturned.

These type of laws clash with constitution. This is Sth Aus case where prosecution was beaten.

The laws are an affront to freedom of association on the bikie front in sa and qld and an interference with private property by the Crown - Both the fault of the executive (politicians) and laws that are unlikely ever to succeed for very good reasons when heard before the High Court.

QWAOMW NWQA!

Translantion:

AWESOME NEWS!

I've only been driving the Skyline a couple of times a week at the moment. Fairly stock model but the front is way too low, have been left alone so far, only been pulled up for non defect reasons so far.

Probably should stop modding the daily too much.

I've heard of a Golf R getting defected for coilovers and an attempted defect for a stock AMG zorst, mind you AMG exhaust note is rather tasty stock.

I've only been driving the Skyline a couple of times a week at the moment. Fairly stock model but the front is way too low, have been left alone so far, only been pulled up for non defect reasons so far.

 

Probably should stop modding the daily too much.

 

I've heard of a Golf R getting defected for coilovers and an attempted defect for a stock AMG zorst, mind you AMG exhaust note is rather tasty stock.

Because there's only one legal ADR approved coilovers which I believe are the tein super streets or something like that anything else is illegal according to the law.

even if u get them engineered?

You can get them engineered. To do so, you would have to lock them in a static height permanently thus ruining your Coilovers. Even then, a lot of engineers don't want to touch then.

To do so, you would have to lock them in a static height permanently thus ruining your Coilovers

by this u mean not adjusting them anymore ?:D

or u have to weld them down? :(

then again... how often do people adjust the height of their coilovers? I know I only set mine once or twice in 3 years :P Would nismo ones sound more "legal" ?;)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • As far as I can tell I have everything properly set in the Haltech software for engine size, injector data, all sensors seem to be reporting proper numbers.  If I change any injector details it doesnt run right.    Changing the base map is having the biggest change in response, im not sure how people are saying it doesnt really matter.  I'm guessing under normal conditions the ECU is able to self adjust and keep everything smooth.   Right now my best performance is happening by lowering the base map just enough to where the ECU us doing short term cut of about 45% to reach the target Lambda of 14.7.  That way when I start putting load on it still has high enough fuel map to not be so lean.  After 2500 rpm I raised the base map to what would be really rich at no load, but still helps with the lean spots on load.  I figure I don't have much reason to be above 2500rpm with no load.  When watching other videos it seems their target is reached much faster than mine.  Mine takes forever to adjust and reach the target. My next few days will be spent making sure timing is good, it was running fine before doing the ECU and DBW swap, but want to verify.  I'll also probably swap in the new injectors I bought as well as a walbro 255 pump.  
    • It would be different if the sealant hadn't started to peel up with gaps in the glue about ~6cm and bigger in some areas. I would much prefer not having to do the work take them off the car . However, the filler the owner put in the roof rack mount cavities has shrunk and begun to crack on the rail delete panels. I cant trust that to hold off moisture ingress especially where I live. Not only that but I have faded paint on as well as on either side of these panels, so they would need to come off to give the roofline a proper respray. My goal is to get in there and put a healthy amount of epoxy instead of panel filler/bog and potentially skin with carbon fiber. I have 2 spare rolls from an old motorcycle fairing project from a few years back and I think it'd be a nice touch on a black stag.  I've seen some threads where people replace their roof rack delete with a welded in sheet metal part. But has anyone re-worked the roof rails themselves? It seems like there is a lot of volume there to add in some threads and maybe a keyway for a quick(er) release roof rack system. Not afraid to mill something out if I have to. It would be cool to have a cross bar only setup. That way I can keep the sleek roofline that would accept a couple bolts to gain back that extra utility  3D print some snazzy covers to hide the threaded section to be thorough and keep things covered when not using the rack. 
    • Probably not. A workshop grade scantool is my go to for proper Consult interrogation. Any workshop grade tool should do it. Just go to a workshop.
    • In my head it does make sense to be a fuel problem since that is what I touched when cleaning the system. When I was testing with the fuel pressure gauge, the pressure was constantly 2.5 bar with the FPR vacuum removed. When stalling, the pressure was going up to 3.0 bar (which is how it should be on ignition).
    • ECUtalk pages don't mention they support the ABS computer (consult port has more than one CAN), so you might just need a different scan tool. But, I would expect ABS is a different light to the brake warning/handbrake light, do you see an ABS light come on for a few seconds when you turn the key from ACC to IGN? But since you said: I'd have a look at the ABS sensors in the rear hubs to make sure they are not damaged, disconnected etc.
×
×
  • Create New...