Jump to content
SAU Community

Recommended Posts

I dunno. I always assumed it was a control fuel like the v8 supercars run, but they were saying at the start of q1 that the fuel supplier to redbull are expecting to gain 1/10th of a second from their new blend.

Whatever they have been using has been damaging the nearly infallible fuel flow sensors.

Maldonado Says Crash wasn't his fault

I can't believe sponsors still want to put their name to him. And I think he could have saved it if he hadn't locked up just before he hit the wall. Car looked like it was about to swing back

Anyway, great to see Dan up there again. Not so great to see that Mercedes are 1 second ahead of everyone. It's hard to believe that they are so far ahead, surely it can't all be engine?

It shows how much better a driver Grosjean is then Maldonado, seen as they were put in the same basket a few years ago

I think Maldonado annoys me so much because he constantly screws up then blames everyone/everything but himself, when alot of the problems seem like rookie errors

The issue now is that its a good thing he has bought money to Lotus now. But I'm worried for what will happen to the team when he decides they must be against him like Williams were because he isn't winning races, and by then Lotus may have lost alot of potential sponsors because of Maldonado. I don't want Lotus to fail

Romain had a cracker! Had problems all race but still grabbed a solid 8th. Was good for a 5th olr 6th if the think ran on all 6 cylinders for the whole GP.

So RBR is clear no.2...from there its l;ooking rather close between Fezz and Williams with Force India and Lotus sticking their noses in from time to time.

LOL, all hail King Dennis...he is doing a stella job at McLaren!!!! :)

Romain had a cracker! Had problems all race but still grabbed a solid 8th. Was good for a 5th olr 6th if the think ran on all 6 cylinders for the whole GP.

So RBR is clear no.2...from there its l;ooking rather close between Fezz and Williams with Force India and Lotus sticking their noses in from time to time.

LOL, all hail King Dennis...he is doing a stella job at McLaren!!!! :)

I dont think the Lotus has the speed to defend down the straights problems or not at the moment sadly

If you looked at the Lotus during the early and closing laps it had the lap speed to keep the Williams honest and Fezz behind....problem was they had an instrument problem that cut power for periods of the race and at times was only running on 5 cylinders :(

Keen to see how Romain goes at Monaco...god knows he over drove last year and had a shocker

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • UPDATE: Yes the GSP Axles are compatible. I installed it on my R34 today and they are working a treat! Turns out that the S13, S14, S15, and 200 SX all used the same axles as the HR34, and ER34 NA models. Which is 2 bolt x 3 pairs.  
    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
×
×
  • Create New...