Jump to content
SAU Community

Formula One 2014


tweety bird

Recommended Posts

If Mercedes walk away with it in Monaco I think thats the season over. If Red Bull stand a chance anywhere, I'd say its in Monaco.

Whats the gap going to be like at places like Monza and Spa this year?

Link to comment
Share on other sites

I know it has only been 5 rounds, but I think that the season is pretty much over anyway. I'm still looking forward to the rest of it though as there has been some good racing so far this year.

As for Monza and Spa, if this weekend is anything to go by, Merc could possibly lap the entire field.

I'm really looking forward to Monaco, and I hope that both Dan and Seb can qualify well and not have any car problems. It'll be good to see where Dan stands now compared to Seb, seeing as SV has found a bit more form and become comfortable in his new chassis. I think they could have some really good duels in the remainder of this season (as long as RBR allows them to race each other).

I can't help but feel Kimi got stooged a little bit in the first round of pitstops by his team.

Link to comment
Share on other sites

called it 2 races ago, Hamo for the WDC barring death, injury or 'team' sabotage. The only other chance is Rosberg.

3/4 is where it's at, the question is can Ricci beat Vettel at the end? I think Vettel had a bad run so far (Ricci's non-podium mega hurt too) so I think Vettel will come back and take out 3rd in the WDC.

Alonso I believe will be fighting with Ricci for 4th.

Link to comment
Share on other sites

If Mercedes walk away with it in Monaco I think thats the season over. If Red Bull stand a chance anywhere, I'd say its in Monaco.

good luck - last year at Monaco Mercedes locked out the front row and won the race, and they set the pole time the year before that...

Edited by hrd-hr30
Link to comment
Share on other sites

It does look like its going to take the two Mercs crashing into one another. The pace they showed after the pace car in Bahrain and the speed last weekend has got to take the wind out of the sails of other teams.

Perhaps if Renault can bring their A-game by Silverstone then the back half of the year we can at least have races where they are pushed...but they would have to take a backwards step in development (perhaps learn that one from McLaren) and lsoe pace relative to RBR finding pace. But, being 1 second quicker in race pace at different circuits speaks volumes.

But, I will hold off on the call that MB will win all GPs until we see the results of Silverstone and Hungary. LOL, I can only hope for a Brawn GP like stumble mid-end of season

Link to comment
Share on other sites

Make McLaren in 1988 look like noobs.

My question is this: With the rules governing the development of engines when is the soonest Renault and Ferrari can copy the long shaft turbo layout in the Benz power plant?

Link to comment
Share on other sites

How can the turbo on the Merc spool so quickly with the extra rotational mass of the shaft? Does the ERS system do all the work or am I missing something here?

Surely on a car without the ERS system this setup would have shithouse throttle response and be quite laggy as well.

Link to comment
Share on other sites

Energy Recovery Systems (ERS)

Long-time fans of Formula One racing will be familiar with the concept of a Kinetic Energy Recovery System (KERS), technology that was introduced to the sport in 2009 and was a mainstay from 2011. KERS worked by harnessing waste energy created under braking and transforming it into electrical energy, providing an additional 60kW (approximately 80bhp) of power for up to 6.67 seconds per lap.

The Energy Recovery Systems (ERS) which form an integral part of an F1 car’s power unit from 2014 take the concept of KERS to another level, combining twice the power with a performance effect around ten times greater.

ERS comprise two energy recovery systems (Motor Generator Unit - Kinetic [MGU-K] and Motor Generator Unit - Heat [MGU-H]), plus an Energy Store (ES) and control electronics.

The motor generator units convert mechanical and heat energy to electrical energy and vice versa. MGU-K works like an uprated version of KERS, converting kinetic energy generated under braking into electricity (rather than it escaping as heat). It also acts as a motor under acceleration, returning up to 120kW (approximately 160bhp) power to the drivetrain from the Energy Store.

MGU-H is an energy recovery system connected to the turbocharger of the engine and converts heat energy from exhaust gases into electrical energy. The energy can then be used to power the MGU-K (and thus the drivetrain) or be retained in the ES for subsequent use. Unlike the MGU-K which is limited to recovering 2MJ of energy per lap, the MGU-H is unlimited. MGU-H also controls the speed of the turbo, speeding it up (to prevent turbo lag) or slowing it down in place of a more traditional wastegate.

A maximum of 4MJ per lap can be returned to the MGU-K and from there to the drivetrain - that’s ten times more than with 2013’s KERS. That means drivers should have an additional 160bhp or so for approximately 33 seconds per lap.
Edited by djr81
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I hadn't got that far, my main worry was the connection to the actual calipers themselves. I'm just using new (ish) stock brake lines in the stock setup. I've just had a stud welded to the knuckle that is a little lower than the original stud (so my knuckles have two studs each side) to not have it be stretched so far in previous BBK setups, so the "block" (in the second picture) mounts a little lower for me and I hope I don't need to change anything. I may have even changed the connection to the calipers in the past and have since forgotten I did that. I may not have. Guess how I'm gonna find out. Source: hopium
    • It's more so I'm using the 1x piece line from HEL that goes from the body to the caliper. There's no middle block/mount like the HFM ones or the GKtech ones. There are certain angles/suspension compression where the line actually slightly contacts the ARB. Below of how mine sit (not my photo): How I want it:  
    • Oh I have mine all sitting in boxes ready to go, two sets of rotors, four sets of pads and caliper rebuild kits. They send a survey asking me if I had installed them months ago :p Grinder not necessary to fit the fronts, and not *really* for the rears. They have some good simple videos on how-to. I don't understand brake lines but from what I understand... somehow... OEM lines work, even though people say 350Z and 370Z use different banjo bolts, so it's possible 350'z had some different setup that Nissan changed to the 370Z/R33/R34 system? ....though are a little short, but past-me made a new bolt hole to bolt them to to reach my current fronts so I should be okay... maybe. In any case HFM don't sell any *different* line kits for R33/R34 front brakes than they do for the 370Z kits. So in my mind they must be compatible or they would have different products made to suit the different calipers. Please test and confirm for me kthx.
    • @Kinkstaah HFM will have a spicy BF sale in November, might be a good time to load up on the adaptors, new lines, etc. Then may the best grinder win lol.
    • I actually think the S15 is 80/20. I know I said 70/30 before but perhaps that is the GTT/GTST one. I wanna say it's the BM50 or BM44. I have one for sale if you want it GTSBoy, try your luck. For some reason the R34 GTT one is actually unlabelled, so it's a BM??????
×
×
  • Create New...