Jump to content
SAU Community

Recommended Posts

Hi my 34 boost sensor has broken. Now im chasing a new one. I tried Ebay and the normal places so i decided to see nissan.

They looked the part up and of course there is none. There system say the part is no longer made aswell but then says see part 22365-6p51a which is a nissan navara boost sensor which

has the same plug and look very similar so my question is has anyone used the navara sensor.

Link to comment
https://www.sau.com.au/forums/topic/444206-34-gtt-boost-sensor/
Share on other sites

http://www.skylinesaustralia.com/forums/topic/297345-m35-factory-boost-gauge-repair/

No brain fart, today at least....

That one above is the Map sensor for the ecu, I assume it has the same terminal setup, but are you after that or the boost sensor for the gauge in the dash?

http://www.skylinesaustralia.com/forums/topic/297345-m35-factory-boost-gauge-repair/

No brain fart, today at least....

That one above is the Map sensor for the ecu, I assume it has the same terminal setup, but are you after that or the boost sensor for the gauge in the dashmy problem

My problem is with the boost sensor at the back on the firewall. I think its the Map sensor but written on the part is boost sensor which is kinda the same thing.

On R34s there are 2 MAP sensors. One is for the gauge and is usually on the driver's side of the firewall, and the other is for the ECU (to know when it has boost) and is more central. I don't know exactly where they are on R34s because my Neo is in an R32 and therefore I have the R32 gauge sensor (to the outside of the brake booster) and the ECU sensor is actually bolted to the top of the engine because there isn't an appropriate place on the R32 firewall.

The sensor in the OP photo appears to be the ECU's boost sensor.

It's not a MAP sensor in the typical term. The only function it provides is boost monitoring. If more than 14psi is seen it provides the ECU with a fault code.

I believe that's the only fiction that it provides.

i was under the impression it did more then just detect 14 psi and chuck a fault code. They found mine was broken when tuning and repaired it that was well over 12 month ago and now its fully f**ked and the car wont even boost with out chugging. i was running over 14 psi with no enging codes with a nistune.

With Nistune you can uncheck the monitoring of the boost sensor. Just like you can do the same for the TCS/ABS systems if they aren't present.

You can't run 14 psi on a standard Neo ECU anyway, because it will chuck a wobble well before you get there anyway (R&R - and probably hit the TP limit from the AFM signal). So you need Nistune to be able to even think about it. So you would just turn off the sensor in Nistune anyway. But if you didn;t want to, you could always arrange for the equivalent of a boost T bleed arrangement to limit the amount of boost that the sensor sees. A simple self-relieving pneumatics pressure regulator would probably do the job. Set it to no more than 10 psi - that's all the sensor would ever see. Job done.

It's not a MAP sensor in the typical term. The only function it provides is boost monitoring. If more than 14psi is seen it provides the ECU with a fault code.

I believe that's the only fiction that it provides.

It does *something* else in the ecu. But what exactly is hard to pinpoint or use to tune.

In nistune there is a boost duty table. It affects that which in turn affects fuelling.

There was a guy that accidently hooked his up to the inlet manifold so it was reading vacuum and the car ran super lean and was un driveable.

All great information but my original question is to do with the replaceing of a broken unit with the navara equivlent that nissan say will work and is linked to now that the origanl unit is no longer made part number

22365-6p51A instead of the 22365-6p500. How would i go about making sure this part is working in the same way as the origanl.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I have been being VERY quiet about what you're alluding to, as it is something that ticks me off... The number of cars from factory that run coil overs is HUGE! Most of them these days do... The other part that annoys me, is people saying "Well all the incabin adjustable suspension is illegal by blah blah blah"... If that's the case, then why can I buy a car brand new that can do it if, FULL STOP in cabin adjustable suspension is illegal...   Also, I could just chuck some aftermarket shocks in my car, throw the stock springs on, after my blue slip, dump my super low springs back in. Same shock and spring style setup... Hell, they could also be the same colour springs etc.     I'm voting, BlueSlipper didn't want to touch the above car for some reason. Whether it be some sort of bias against the car, the owner, them maybe having previously done dodgy shit and now they're being super careful in case they get slapped in the face by the Gumbyment again... Find a new blueslip place.   And can confirm as you had said, yes there are holy bibles of vehicle heights, and all sorts of other suspension stuff. Heck your run of the mill mechanic, and tyre shop has access to all of that stuff. It's how they do wheel alignments...
    • Funny story Heading to Sydney this morning on the HWY there was some slow traffic, so I gave it the beans and midway through my overtaking "power run" I lost all power It seems that I missed a hose clamp,  and the MAF and filter went WiFi To make this more problematic, the little tool kit that lives in the boot, is sitting in the sun room at Goulburn......LOL Luckily for me I found a bit of steel on the side of the road that could be used like a rusty and bent flat head screw driver to tighten it up enough that it got me into Sydney, it is now all tight like a tiger with the aid of a 8mm socket Note to self: Use my brain and double check stuff, and always keep that little tool kit in the car for when I have a brain fart
    • Oh, and as for everyone with their fuel economy changes, I switch between E10 and 98 in the company car. Even do when I had personal cars that could run on E10. You know what changed my fuel economy in any noticeable way? How I drove, and where I drove. Otherwise, say on full tanks of just back and forth from work only (So same trips, same sort of traffic), couldn't notice a difference that I can correlate to the type of fuel in use. In the current vehicle, that's over 42L of USABLE fuel. While 98 is all "more energy dense", it also has higher knock resistance as it takes more energy to get it to ignite too. The longer hydrocarbons, typically more tightly bound. So running the same ignition map, can also produce less power, if there isn't enough time to get it all burnt through properly, as yep, the flame propagation speed is different from lower octane fuel to higher (Higher has a lower flame propagation, due to the more tightly bound and harder to self ignite funs. This is also typically where, a vehicle that is designed purely to run on 91 (Whether it be E10 or normal 91) usually sees absolutely no real world difference in fuel economy for the normal man, woman, or dog.
    • We've got some servos around me that have 91 with E10, 91 (no E10), 95, and 98. At those stations the change from 91 E10 to 91, is typically around 8c/L.   But lets not get started on the price of fuel in Oz. It's ridiculous. All the service stations around me, bar one, the price of fuel has been over the $2 mark per litre for the cheapest, 98 being around $2.45. That one service station is a CostCo, fuel from it comes from the same refineries, and makes no pitstops, it runs great, including the 98. In fact, I've had no issues on CostCo fuel, but plenty of issues at other stations!. The CostCo fuel, was $1.65 roughly this week for 94 with E10. $1.88 for 98. Servos directly across from it, $2.10 for 91 E10, and $2.48 for 98. The part I had to laugh at? If I drive multiple HOURS away from Brisbane, say out near Nanango, or Kingaroy, or even out to Goondiwindi, the price of their fuel, is the same as what it is at the CostCo... Oh, and that BP servo at Goondiwindi is HUGE and goes through epic turnover of fuel, so it's not sitting there for weeks going to shit. And what blows me away, my mate is one of the people who drives the Fuel Tanker all around QLD, delivering to all those places. At the same company his previous role was doing the "local haul" deliveries... Same truck, same driver, same pickup point it all comes from. So you tell me, how the hell it is 60c/L CHEAPER for fuel, when nearly all else is equal, except they require a B-Double to drive half a day out of Brisbane, and half a day back, every second day, compared to the delivery that can be under 30 minutes drive from the fuel pickup point... Not to mention, go five blocks down the road, and Ampol to Ampol will vary 30c/L... And I've had this conversation with my mate... The way it's priced, is just typical, pure and utter rubbish... He also does runs from Brisbane, to all over QLD, down to Newcastle, Sydney, Nowra, Melbourne, Geelong, and even out to parts of the NT depending on the companies needs. His main stuff is all the longer distance away from home for a few days at a time, then when he's back, he loves to just pickup extra shifts wherever he can in whichever truck, hence all the weird different places.   Oh, as for getting E10 into all the fuels in Australia... It was very quickly highlighted, that we don't have enough biomass available to use to make E10 sustainably like they require, and it would dramatically cut into our, and the worlds food chain supply...   I vote we all just start running on liquid methane gas... Plenty of that just getting tapped off at tips from underground decay... (Note, this is pure just stupid commenting. I could very easily highlight the reasons its not a good idea especially on scale...)
    • Am I correct in assuming that the R35's are getting the classic skyline haircut off the odometer?  Quick search on carsales, there are 33 08 and 09 GTR's for sale, only 2 of them have more then 100,000km's on them (116,075 and 110,000 respectively).  And somehow there are about 25 for sale with around 60,000kms? Looks like the classic skyline haircut to me =/
×
×
  • Create New...