Jump to content
SAU Community

Recommended Posts

<p>Hi,</p>

<p>My 1994 R32 GT-R has two possibly related problems. After driving for about five minutes the power steering basically shuts down and the steering is heavy as if it has no assistance, at about the same time the HICAS light comes on.</p>

<p> </p>

<p> </p>

<p>The power steering fluid level is normal as is the reservoir in the boot. My mechanic says the power steering pump is not showing any obvious signs of problems and the car is genuine low mileage and generally mechanically excellent.</p>

<p> </p>

<p>Any suggestions, before I take this to Nissan?</p>

<p> </p>

<p>Note that the steering returns to normal when you switch the car off and start again though I have not worked out how long it takes to "reset".</p>

Link to comment
https://www.sau.com.au/forums/topic/446077-heavy-steering-and-hicas-warning/
Share on other sites

Similiar problem with my 33, it could be the g-sensor under the center console,or the capacitors in the hicas computer, because of there age they start leaking fluid.i replaced the g-sensor with a digital one from nengun about $500 and had the local tv repair man replace the capacitors in the computer for about $70.

Had the exact issue with my 33. Hicas computer faulty. Picked up a second hand one for $50. I was able to swap it with a friends 33 just to be certain before I replaced it.

Edited by Aazzy

Hi. Car had a aftermarket steering wheel, but I swapped it for a stock one. The problem remained.

Just tried several times to invoke HICAS diagnostics mode but it just won't play ball. I guess this might indicate a faulty HICAS computer as mentioned in above posts?

Maybe. Nut that's why I suggested if you fail at getting it into diag mode on your own that you use a proper scan tool. The method for getting it into diag mode relies on various inputs still working (steering angle sensor, brake signal, vss, etc). If one of those is faulty then you can't get into diag mode to find out that it is faulty.

By "proper scan tool" you mean something that any Nissan workshop would have or are these some more specialised? Anyone in Adelaide want to recommend the best mechanic/workshop or Nissan service centre to work on this problem? I've had other work done at Main North Nissan, but they don't seem that good e.g. didn't know how to adjust the air/fuel mixture on a Datsun 280ZX!

The reservior in the boot is for ATTESA not HICAS. Also the G sensor isn't used by HICAS AFAIK (R32 remember).

Most likely the computer under the boot. Unplug the smaller plug (there are two) and see how you go. The computer is located on the driver's side, under the parcel shelf.

The manual steps to invoke the diag mode is a pain, it took me a few tries to get it working.

By "proper scan tool" you mean something that any Nissan workshop would have or are these some more specialised? Anyone in Adelaide want to recommend the best mechanic/workshop or Nissan service centre to work on this problem? I've had other work done at Main North Nissan, but they don't seem that good e.g. didn't know how to adjust the air/fuel mixture on a Datsun 280ZX!

Brenton @ Foursnmore in Pooraka has a scan tool that I have put onto my car and seen every computer come up for diagnostics (granted, that's only the ECU and the HICAS these days...not having TCU or ABS modules in the car reduces the possible number you can see!). And also on things like auto Legnums I've seen the ECU, TCU, ABS, etc all come up and drop their pants for inspection. So much easier than trying to make diagnostics happen manually.

  • 1 month later...

An update on this. Main North Nissan sent the car to Clisby who took the HICAS ECU apart and cleaned it up a bit, but still faulty. I'd like to track down another ECU but the ones on ebay have quite different part numbers. My has part number 28505 12U00 and serial 4623. I can't find anything like this. Would a ECU with number 28505 04U00 work? Does anyone know how to interpret these part numbers? Was my 1994 unique in having this HICAS ECU part number?

  • 2 years later...

Update on this for anyone interested. I've owned the car a few years now and still no resolution to this issue. Within a few minutes of switching the car on I get zero power steering, followed a few minutes later by the HICAS light coming on. I know the HICAS is all working (passes all diagnostics) so this continues to be a mystery of the Universe, right up there with Dark Energy and Dark Matter. I'm calling this Dark Power Steering Failure.

If you have eliminated the hicas ecu as the issue, then you can try removing the cluster and have a good look at that, you will need to take it right apart and examine where the taco mechanism seats into the cluster. What you are looking for, is a small electrical plug that takes the rpm signal from taco and joins it to the rest of the clusters wiring. Carefully clean the contacts and make sure the plug is seated correctly when you reassemble. While you have the cluster out, make sure you clean (very carefully), all those annoying cooper trace connecting wires at the back of the cluster, and be very careful with the end of the taco cable too.

 

 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Maybe they'll look to do a bunch of presales to help inject some cash fast for their financial issues...
    • Does it also misfire equally when revving?   Josh is very correct in what you should do. The coilpack harness wiring loom itself is a known problem due to its age and the number of heat cycles it has gone through. Throwing parts at a vehicle to diagnose the issue isn't a smart or good way to do it. Secondly, you may have a bad coil pack, you pop replacements in, they fix that issue, but messing with the harness breaks it, so the issue persists. So now you think "well it wasn't the coil packs" and have to continue chasing your tail, potentially swapping back in your shit coil packs and returning the good ones (yes, I've seen people do this because 'it wasn't the problem' and they want to save money). And suddenly, you've got two issues with the same symptoms...   Diagnose, don't use the spare parts shotgun.
    • Well the articals keep saying a Q50s (Skyline in Japan) with a new Manual gearbox. I like the talk about the new looks with the round tail lights. I hope they bring back the retro look like they did with the Z
    • Off the back of feedback we have decided to mix up this next Motorkhana at Avalon to have some targeted skills practice for beginners to advanced. Saturday 6th September 2025 8:30am Capped 26 entries Standard Entry Fee: $89 Members Entry Fee: $55 (SAU Victoria Only) Entries Close: Friday 5th February  Where: 55 beach road Avalon. https://maps.app.goo.gl/HNUE3EuNue3sJxh38 Entries: Limited to 26 entrants (Passengers allowed over the age of 14 with a signed disclaimer and same safety gear) Disclaimer: Download  Please electronically sign and email to [email protected] or print and hand in and Driver Sign In. To compete in this event you will require A valid  AASA General Speed licence or (Day license via the AASA Website for $50) MA Licenses are no longer accepted by AASA https://aasa.com.au/  A helmet, long sleeve clothing and a 1KG mounted fire extinguisher recommended (But not Mandatory). Further details within Supp Regs on the enty link. Entry Link > https://www.sauvic.com.au/entry/deca/20250906 You can bring and have a passenger in the car but they need to comply to the same safety and clothing as driver. Bring your car and get to battle others, win, lose or draw. I can guarantee you will have lots of fun. Any questions email [email protected] Entry List: 1.Anna S 2. Luke S 3. Jesse Givens-Lamb 4. Luca Stamatescu 5. Madeleine Stamatescu    
    • Wanna rewrite all of that in, say, 2 or 3 separate sentences, so that we can read it?
×
×
  • Create New...