Jump to content
SAU Community

Recommended Posts

They're not random, they're images from the first post or the OP's avatar.

What makes them so cumbersome?

well, actually you can change the pictures to whatever you like and it changes for everyone. inb4 NSFW related thumbnails being posted.

  • Like 1

well, actually you can change the pictures to whatever you like and it changes for everyone. inb4 NSFW related thumbnails being posted.

Thanks! It was supposed to be authors only.. :(

  • Like 1

Have to agree, the pics take up too much space for me. I liked the single lines. Think it makes it easier to see what threads I have posted in or read etc.

Could we have it as an option to have the thumbnail before posts or not?

PranK: Very much appreciate all the updates lately, keep up the good work (Y)

Hmmm ... Ok ... So, I'll disable it until its an option. That was going to be the next update.

Under one condition. Each of you tell me when the last time you noticed downtime was. ?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I've never played with one, but I would expect that you are correct. That slot looks like it is intended to be used to unscrew the end, and the flats on the body would be better than grabbing it around the round bit with a pipe wrench. So, yeah, probably unscrews. You'll probably have to make a tool to drive in that slot.
    • A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
×
×
  • Create New...