Jump to content
SAU Community

Recommended Posts

So I know I might get judged really badly for this but I need assistance. Like an idiot I filled up my tank with 91 octane because there were no other options since I was driving out of town (I live in a very rural area). I didnt get any issues initially and the car drove fine. However, today the car misfired and my check engine light is now on and is staying on. Could that be because of the fuel or would it be an issue with the coil packs? 

 

Please help. 

Link to comment
https://www.sau.com.au/forums/topic/472959-check-engine-light-on/
Share on other sites

running on 91 is perfectly safe assuming you were just pottering around. If you floored it up a hill and noticed but ignored the sound of a small rock rattling in a tin then you've likely f**ked your engine.

Is the car idling and running OK? Do you have 98 in it again now?

It's most likely not related to the fuel, but you still need to find out what the error code is.  Any local mechanic could put a scanner on it, or like Callan said there would be a tutorial on here somewhere on how to get it into diagnostic mode to tell you what the error is

I did floor it a bit. not completely and it was not uphill. The car misfired and since then I've only been driving really gently. The car runs fine for now. I haven't put 98 in yet because im still on a quarter with the 91 fuel. If i am right, when it goes to half, I could fuel up with 98 then to make it closer to a 95? I might give the diagnostic tutorial a go and see what pops up. 

Yeah, I'd fuel up at 1/4 tank with 98 and yes you end up with the average octane so that will be OK.

I've been caught a few times without high octane when I'm out and about and it's fine. Actually back in the day when I was out at Alice Springs for 6 months my old 33 ran on only 91 and it survived OK....you only need the whole octane rating at maximum torque / maximum load. So if you aren't flooring it up a long hill in 4th at full boost it's fine.  Aftermarket tunes are almost always less tolerant to make more power but factory is pretty safe.

So a quick update. I drove to work this morning and drove it gently again as i did for the past few trips. The engine light check went off on its own and hasnt appeared since. I'll keep on driving it gently and maybe after putting 98 in and waiting for a day or two, ill try to floor it and see if it misfires. 

 

That's my issue, i live in katherine and to get premium fuel here is quite hard. Only a few places provide it but after this has happened I definitely will ensure that I always have premium fuel in. 

If you can control yourself it's safe enough....its just hard to be good all the time :)

The quick option is to lower the base timing by 2-3o, that should make the factory tune safe on 91. Just need a timing light to do it correctly. Of course it won't be as crisp in the midrange but at least it will be safe on low octane

So update again. after two trips the engine light came back on. I stopped the car. started it again and drove for around 200 metres and it went off again. This has already happened twice today so I'm quite concerned. I did the self diagnostic as well and it came back with code 55 meaning everything is fine. Also topped up with 98 just before. How long would it normally take for the fuel to mix properly and make a higher rating? Not willing to floor it yet just in case I get more misfire and damage the car. 

Edited by Hacexd

well, that sort of depends whether it's actually on boost when the gauge doesn't work or not :P

a missfire can stop the engine running well enough to create decent boost.  Alternatively, an electrical issue like a bad earth, dying alternator etc could also cause a misfire. There's just too many reasons to really guess without more information.

Is your current situation that you have mostly 98 on board, you drove it 5 times yesterday, you haven't had a MIL for the last 3 trips, and it missfires? And where specifically does it misfire, approx which revs? And does it misfire if you free rev it or only when you are driving it properly under load?

If it is just light missfire in the mid range under load it is most likely a spark plug or coil pack issue. start by pulling the plugs out and checking their condition and gap. If the gap is over 0.8mm gap them down to that and see how that goes.

I might try to bring it to a mechanic on wednesday and see if they can find anything because as you've said, there are a lot of possibilities here. I filled up 98 when I was around half a tank on 91. No I haven't had a MIL for the few trips that I've done and yes it still does misfire. It probably misfires around 4.5-5k revs i would say. It only misfires when driving it properly under load. I do have to rev the car quite high to make it happen as well. The car just hesitates for a bit when it reaches the revs I specified and then after a few seconds it gets a sudden surge of acceleration like it should.

 

I was actually thinking spark plug or coil pack as well but at the same time, I just talked to the previous owner (I had the car for a week now) and I asked him if he changed the fuel filter and he did say that he doesnt recall when he changed it. So i might get the fuel filter changed as well and see the results. 

The only issue with all of this is knowing exactly what's going wrong and I hope the diagnosis will find out the specific problem. 

Thanks a lot everyone for your help as well. 

I had this once after switching fuel brands, all 98

I’d been running on BP for ages and then out some Mobil 98 in, and got the check light after giving it a bit

The code it threw up was the O2 sensor

It did it a few times but haven’t seen it since. That was about 4 years ago

So quick update again. Ended up getting a fuel injector cleaner. I put it in the fuel tank and fueled up with 98 again and dropped the psi a bit on the turbo and car is running fine. No more hesitation on boost at all. Potentially just needed to be fueled up again I believe. I would also like to help everyone for your help on this matter. I spent a whole week worrying about what it could be and reading about it day and night on every forums lol. All solved though. 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • That's not a transistor --- it's marked ZD1 which makes it a zener diode. As to what the breakdown voltage is, not enough there to divine.
    • Hi all, Long time since I've posted here. Looking for some advice on what I can remove to further identify the cause of my issues.  I can move the passenger seat forward and back but the knob used to adjust the seat angle is pretty much free spinning, there's very little resistance.  Removing the side cover I can see that the chain is intact but the shaft for the adjustment spins without the gear attached to it moving.  What's my next step for disassembly here? Is this a common fault? Just being a little cautious as I didn't want to start removing bolts for a spring to fly out or something equally as stupid.  Cheers
    • The incentives are mostly the same, yes. Ethanol is cheap compared to the cost of doing 98-100 RON with crude oil alone. 87 to 93-94 AKI all with E10. In 2020 Canada mandated E10 as a part of their "renewable fuel standard" and is supposedly going to go to E15 in 2030. In California where there are only 8 refineries with two threatening to shut down next year it's been over 20 years now of E10 and 91 AKI maximum because there's just not enough refinery capacity or crude oil supply relative to the demand for premium unleaded fuel. And CARB's low carbon fuel standard means functionally none of the diesel available at the pump is made from crude oil anymore. It's almost all entirely 20% biodiesel blended with 80% renewable diesel (hydrotreated vegetable oil) now. The number of gasoline vehicles that support E15 or higher ethanol concentrations is surprisingly low, I can't imagine it being wise to play tricks like this without flex fuel sensors in most of the fleet.
    • It's almost certainly the same as the one next to it. Have a fish around amongst these hits https://www.google.com/search?q=surface+mount+transistor+m33&sca_esv=9cb49794e0b2005d&source=hp&ei=2vJ5aNjTB7Kw0PEPldnS8QM&iflsig=AOw8s4IAAAAAaHoA6qkfmF6XcygtrZ4Vu9f92NXF_RFd&ved=0ahUKEwjYqIPP7MWOAxUyGDQIHZWsND4Q4dUDCA8&uact=5&oq=surface+mount+transistor+m33&gs_lp=Egdnd3Mtd2l6IhxzdXJmYWNlIG1vdW50IHRyYW5zaXN0b3IgbTMzMgUQIRigATIFECEYoAEyBRAhGKABMgUQIRigAUjKCFAAWABwAHgAkAEAmAHfAaAB3wGqAQMyLTG4AQPIAQD4AQL4AQGYAgGgAuYBmAMAkgcDMi0xoAfMBLIHAzItMbgH5gHCBwMyLTHIBwU&sclient=gws-wiz
    • South Australia, which is hardly as far behind as the rest pf Oz makes out, and who is also not a paragon of progressiveness (read that as over-legislation) in the area of vehicle standards, has this to say on the subject: Adjustable coil-over suspension Aftermarket adjustable coil-over suspension components are suspension units that incorporate an external thread on the main body and corresponding threaded spring saddle that allows the vehicle's suspension height to be varied. If fitting aftermarket or coil-over suspension components you must submit an Application to modify a light motor vehicle form and a report from a light vehicle engineering signatory (LVES).
×
×
  • Create New...