Jump to content
SAU Community

FUEL! Optimax, Ultimate, or Synergy 8000

geno8r

By geno8r,
in R Series (R30, R31, R32, R33, R34)

 Share

Recommended Posts

geno8r Grand Master

geno8r

Posted
Posted

Hi

I'm getting my car dyno tuned very shortly and the mechanic asked me what fuel i usually run. I said optimax. He said that they tested fuels and for the best tuning results it was.

1. Ultimate

2. Synergy 8000

3. Optimax.

Now i've done a little searching around on the net and it seems that it's a fight between Synergy and Ultimate for the best tuning performance.

Now to be vehicle specific with skylines... Can any1 post what they've had their car tuned to and what their mechanic said about tuning with certain fuels.

Cheers,

  • Replies 46
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

makaveli Mentor

makaveli

Posted
Posted

On 3 occaisions I have used Optimax and during all three my car ran like shit, It also caused my cat to stuff up.

I have used Ultimate and it seems great, although I always used Synergy without a doubt as its always been great with my car.

take it easy

Mark

clarkey Proficient

clarkey

Posted
Posted
Hi

I'm getting my car dyno tuned very shortly and the mechanic asked me what fuel i usually run.  I said optimax.  He said that they tested fuels and for the best tuning results it was.

1. Ultimate

2. Synergy 8000

3. Optimax.

Now i've done a little searching around on the net and it seems that it's a fight between Synergy and Ultimate for the best tuning performance.  

Now to be vehicle specific with skylines... Can any1 post what they've had their car tuned to and what their mechanic said about tuning with certain fuels.

Cheers,

Yeah thats probably the same order I'd use them as well. Ultimate is probably more difficult to locate but only optimax if I cant find the other two

sewid Grand Master

sewid

Posted
Posted

I always run Ultimate but will settle for Synergy 8000 if that's all I can find.

Optimax has given me less than good results. It's a shame though because it's easy to find where I live but I have to drive 5k's to get Ultimate :cheers:

Essential Community Regular

Essential

Posted
Posted

I have found Ultimate to be the best out of the

Ultimate vs Optimax battle..

I was once informed that Optimax is 'Up to 98 ron'

where as Ultimate 'Is 98 ron'

Anyway my advice is, pick a petrol and stick to it .. dont keep changing fuels or alternating between synergy and ultimate.

I have also found...

shit.. i forgot what i was going to say :cheers:

abcent Mentor

abcent

Posted
Posted

Currently using Synergy8000, was usung optimax for ages.....noticed the fumes (exhaust) did actually smell more, an the synergy8000 runs cleaner. Not really fussed between Mobil or BP 98 fuels, both seem to be a good product. But like most, only opt for Shell when have to.

fade Apprentice

fade

Posted
Posted

Never had any experience with synergy, but I have talked to a couple of people in the know and basically what I was told was that Ultimate is refined to get 98 ron and Optimax just uses additives to get 98 ron. For this reason the Optimax will lose ron faster then Ultimate.

FATGTS-R Experienced

FATGTS-R

Posted
Posted

Everything I have read on public forums indicates the ultimate fuel to be the superior product.

But for some reason I get a noticeable improvement in fuel economy with optimax. Approx. 1-1.5km/L better.

I have seen many people mention the arguments about the optimax being "up to 98ron" and that it has additives to raise the ron level and ultimate is refined to 98 ron.

Does anybody have any documentation or links on the web to support these claims?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • JC71
      new 1.5 LSD issues/concerns

      By JC71 · Posted

      sold listed as a Tomei LSD 1.5 Way For 1998+ Nissan Skyline ER34 25GT RB25DE w/Open R200 https://www.ebay.com/itm/174006114594?campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=&mkrid=711-53200-19255-0&loc_physical_ms=108689&loc_interest_ms=&campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=71883f2ccc571356e0a757bc7adfdde2&mkrid=710-53481-19255-0&loc_physical_ms=108689&loc_interest_ms= it went in like butter all gears, alignment, back lash etc, rotation and clearances correct, and if rolling all rotates smooth and free when coasting down road , clutch in or out over 10 mph smooth... its the binding, clunking and jerking from a stop that is most concerning, also seems like its going to tear the tires off in 10 miles of normal road driving. 
    • Kinkstaah
      new 1.5 LSD issues/concerns

      By Kinkstaah · Posted

      What 1.5 way? There's no such thing really as a 1.5 way, just different ways of explaining 2 ways with different ramp rates. HOWEVER. In any driving in a straight line your 1.5 or 2 or 1.7 way should have no clunking at all. With the clutch fully depressed the diff should be silent (unless it's welded but I'm assuming it's not). Something aint right here.
    • JC71
      new 1.5 LSD issues/concerns

      By JC71 · Posted

      Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • JC71
      new 1.5 LSD issues/concerns

      By JC71 · Posted

      looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Matt Z
      SAU NSW - Archies Flame Grille Meet & Cruise to Kurnell

      By Matt Z · Posted

      Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
×
×
  • Create New...