Jump to content
SAU Community

Recommended Posts

for 90 degree corners, on the street where the limit is 60, the ratio of 2nd gear is usually right for exiting the corner. imagine putting it in 5th and trying to accelerate back up to 60 :P

after a month or so of practice, you'll probably look back at this question and just think "because".

Link to comment
https://www.sau.com.au/forums/topic/103788-why-2nd-gear/#findComment-1907403
Share on other sites

its actually all about your speed when you turn. the reason y your instructor told u to turn in 2rd is becoz the 2nd gear would be more suitable for you when u come out of the corner, u are on your right gear and ready to accelerate.

if u can handle turnin a lot faster, of course u can turn in your 3rd gear but for a beginner, it is not safe to do it.

Link to comment
https://www.sau.com.au/forums/topic/103788-why-2nd-gear/#findComment-1907435
Share on other sites

As long as the engine isn't labouring too low in the rev range, or screaming its tits off on the rev limiter, the choice of gear is entirely up to you. Having speciffic gears for speciffic occasions is good when you first start learning to drive as you haven't developed good gear selection judgement.

But with today's 5 and 6 speed gearboxes, there are often more than one than one ratio to suit a given occasion. On a 50km/h back street, I may choose 3rd, 4th or 5th gear depending on situation, gradient and mood. Going through corners and roundabouts I might choose 1st, 2nd or 3rd again, depending on mood, radius and situation (or 4th gear if I'm in Mum's Alfa Romeo - man that things torquey for an atmo 2 litre!).

Oo...I was under the impression if I turn on 3rd gear it'll damage the car....also I was adviced to change gear only after I exit the corner completely..is this necessary?

Won't damage the car in 3rd gear unless the engine is labouring (which you will feel and hear). Changing gear only after exiting the corner completely is about keeping your driving smooth. A mid corner gear change can be difficult to get smooth without practice.

Edited by Big Rizza
Link to comment
https://www.sau.com.au/forums/topic/103788-why-2nd-gear/#findComment-1908626
Share on other sites

How to turn a perfect 90 degree corner:

- Slow down from 100km/h to about 30km/h by the time you reach the corner.

-Turm the steering wheel in the selected direction (left or right) as you push the clutch all the way in.

- Rev the engine up to 5000rpm as you enter the corner and then dump the clutch.

- As the ass slides outwards and you car overcorners, spin the wheel back in the opposite direction and slowly let of the revs letting the wheels regain traction while maintaining the car in a forwards direction.

- Check for cops.

- Stick your hand out the window and give a thumbs up to the school girls you almost cleaned up.

- Continue accelerating back up to 100km/h as you bask in glory.

Link to comment
https://www.sau.com.au/forums/topic/103788-why-2nd-gear/#findComment-1909122
Share on other sites

How to turn a perfect 90 degree corner:

- Slow down from 100km/h to about 30km/h by the time you reach the corner.

-Turm the steering wheel in the selected direction (left or right) as you push the clutch all the way in.

- Rev the engine up to 5000rpm as you enter the corner and then dump the clutch.

- As the ass slides outwards and you car overcorners, spin the wheel back in the opposite direction and slowly let of the revs letting the wheels regain traction while maintaining the car in a forwards direction.

- Check for cops.

- Stick your hand out the window and give a thumbs up to the school girls you almost cleaned up.

- Continue accelerating back up to 100km/h as you bask in glory.

haha love it :lol:

i mean no, bad influence!

Link to comment
https://www.sau.com.au/forums/topic/103788-why-2nd-gear/#findComment-1909234
Share on other sites

your instructor wants you to go slow around corners so you dont crash. going fast around corners = pain

my cars auto and i still throw it into 2nd when im doing corners.

that's not cool, you'll stuff the gearbox doing that. it's undue stress. those auto gearboxes are designed to be driven in Drive gear. 1 and 2 (or more if you're lucky) are mainly for hills. do you see a clutch on that thing?? just a heads up

Link to comment
https://www.sau.com.au/forums/topic/103788-why-2nd-gear/#findComment-1909736
Share on other sites

....also I was adviced to change gear only after I exit the corner completely..is this necessary?

I guess you wouldnt call it "necessary" for driving when licensed but for a driving test yes it is. He would of also told you to make sure you have selected second gear before you start to turn.

It's to do with "vehicle control". They (testers) want you to have full control of the vehicle during a turn, meaning both hands are to be on the steering wheel during the whole of the turning manouvre i.e dont up/downshift during the turn as you will be driving with one hand for a moment.

Dont remember back to my P plate test but on the numerous heavy vehicle tests I have done it was an immediate failure to down or upshift during a turning manouvre.

Link to comment
https://www.sau.com.au/forums/topic/103788-why-2nd-gear/#findComment-1910551
Share on other sites

Cornering? Piss easy. As already said & is true is that 2nd for the speeds you "should" be doing the correct speeds for that gear to be on suitable rpm. Brake in a straight line, finish your gear change before your turn, slow in fast out etc etc.........

ctjet, grow up.

Link to comment
https://www.sau.com.au/forums/topic/103788-why-2nd-gear/#findComment-1910561
Share on other sites

Oo...I was under the impression if I turn on 3rd gear it'll damage the car....also I was adviced to change gear only after I exit the corner completely..is this necessary?

As other people have said, it'll only damage the engine if you're so low in the rev range that you make the engine lug.

But, as a learner, you shouldn't be screaming around corners so second gear should be the "right" one for a novice.

With a bit of experience, for street use its not dangerous to change gear mid corner. If you're at the limit its not exactly smart to go changing gears (since it really messes with the balance of the car), and for a novice it might be asking you to do a few too many things at once.

Don't forget, the driving instructor is there to each people who have little to no driving experience what is the "best practice". Once you start driving, you'll find out which best practices aren't mandatory for commuting (stuff like push/pull steering, which is good to learn but almost useless in a modern passenger car).

Link to comment
https://www.sau.com.au/forums/topic/103788-why-2nd-gear/#findComment-1910585
Share on other sites

thanks for the advice..so now I can turn in 3rd gear..muahhahaha

but still when exiting the corner..it's gonna be slow to accelerate if at 3rd gear~~ I'll stick with 2nd I guess...unless insanely fast

Link to comment
https://www.sau.com.au/forums/topic/103788-why-2nd-gear/#findComment-1911303
Share on other sites

Your instructor told you to go around the corner in second gear because this is the 4th step in the system of vehicle control.

First is identify the hazard.

Then check your road position and adjust accordingly.

Check your mirrors.

Gears/brakes.

Indicate for the relevant hazard

After completing the driving task continue on at the speed limit/with traffic flow.

(I am doing a driving instructors course at the moment, and couldn't help)

Link to comment
https://www.sau.com.au/forums/topic/103788-why-2nd-gear/#findComment-1916707
Share on other sites

  • 2 months later...
How to turn a perfect 90 degree corner:

- Slow down from 100km/h to about 30km/h by the time you reach the corner.

-Turm the steering wheel in the selected direction (left or right) as you push the clutch all the way in.

- Rev the engine up to 5000rpm as you enter the corner and then dump the clutch.

- As the ass slides outwards and you car overcorners, spin the wheel back in the opposite direction and slowly let of the revs letting the wheels regain traction while maintaining the car in a forwards direction.

- Check for cops.

- Stick your hand out the window and give a thumbs up to the school girls you almost cleaned up.

- Continue accelerating back up to 100km/h as you bask in glory.

i did what he states and i got some cheers and almost a ticket from the cops :ermm:

its recommended if ur a beginner =)

Link to comment
https://www.sau.com.au/forums/topic/103788-why-2nd-gear/#findComment-2067842
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You just need to remove the compressor housing, not the entire turbo. I would not be drilling and tapping anything with the housing still on anyways. 
    • So, I put my boat on a boat. First of all, I'm going to come out and say it. Why is Tasmania not considered a holy goal, an apex that all road-legal modified cars go to, to experience? This place is an absolute wonderland of titanic proportions. If people are already getting club runs for once in a lifetime 30 person cruises to Tassy then I've never seemed to see it. It is like someone replaced the entire place with an idyllic wonderland for cars, and all of the people living there with paid actors who are kind, humble, and friendly. Dear god. After doing a lap of almost all of the place I've found that it's a great way to find out all of the little things that the car isn't doing quite right and a great way to figure it all out. All in all, I drove for 4 hours a day for a week and nothing broke. I didn't even need to open the engine bay. This is by all means a great success, but it has left me with a list of things to potentially address. I also now have a 3D printed wheel fitment tool which annoyingly hasn't got any threads in it to actually assemble it. I might be able to tape it together to check the sizing I actually want to use, but it'll likely involving pulling the shocks out to properly measure travel at least at the front, and probably raise the car while I'm at it, at least in the rear. I scraped on quite a few things and I'm not sure how else to go about it. I was taking anything with a bump at what felt like 89 degree angles. And address those 10 other tasks. And wash the car. God damn it is dirty. And somehow, the weather was perfect the entire time - And because I was on the top of Mt Wellington it turns out it was very much about to freeze up there. I did something I typically never do and took some photos up there in what must have been -10 and the foggy felt like suspended ice, rather than mere fog. If you own a car in Australia, you owe it to yourself to do it.
    • Damn that was hilarious, and a bit embarrassing for skylines in general 😂 vintage car life ey. That R33 really stomped. Pretty entertaining stuff
    • Hi, I have a r32 gtr transmission. Does any of you guys have an idea how much power it will hold with the billet center plate and stock gearset? At what power level and use did yours brake with or without billet plate? Thanks, Oystein Lovik
    • Saw this replica police car based on a Mitsubishi Starion XX parked next to a 'police box' (it's literally a box) in Hirohata, Himeji City in Hyogo prefecture the other day. It's owned by Morii-san who is a local Mitsubishi Starion enthusiast. According to a local radio station blog post, he always wanted to make a police car himself based on ones he saw in his favourite Manga comics.  As it's illegal to modify a car to look like a police car and drive on the road, Morii-san tried many times to get permission from Aboshi police station headquarters nearby. They refused initially by after they got tired of that they granted him permission. However, the car can only be displayed on private property and obviously can't be registered as long as the police livery is present. The car was completed at a cost of 1.5 million yen (US$ 10,000) in addition to the car cost. A location was chosen outside Hirohata Police box where the car can easily been seen from the street. Morii-san has two other Starion road cars, both widebody GSR-VRs.
×
×
  • Create New...