Jump to content
SAU Community

Recommended Posts

Hi everyone.

A colleague at work has put a deposite down for a 1998 R33 GTS-T.

I was wondering if they exist, or has be had a dodge pulled on him.

I heard that the last run of 33's was in 1998 but they are hard to find.

Can anyone confirm or disprove this?

Any help would be much appreciated.

Link to comment
https://www.sau.com.au/forums/topic/128386-1998-r33s-do-they-exist/
Share on other sites

Yes.. they do exist.. I have one + i think there is a couple of other floating around..

made in 05/98

Most are 40th anniversary, in fact haven't seen one that wasn't.. I would def check in Nissan FAST - this will tell you exactly when it was made (what batch)..

They have a black CAS

That's about the only way to visually identify them..

Edited by Links

True, they exist.

I have one too :P

As already said 1998 is the 40th anniversary.

Should be extra sewn on badges on the front seats

And matching emblims on the C-pillar

Other than that, same as a 96-97 Series II

My avatar shows the outside badge

Yes.. they do exist.. I have one + i think there is a couple of other floating around..

made in 05/98

Most are 40th anniversary, in fact haven't seen one that wasn't.. I would def check in Nissan FAST - this will tell you exactly when it was made (what batch)..

They have a black CAS

That's about the only way to visually identify them..

hahah shit your 33 is younger than my 34 !!!

mines 03/98

Yes.. they do exist.. I have one + i think there is a couple of other floating around..

made in 05/98

Most are 40th anniversary, in fact haven't seen one that wasn't.. I would def check in Nissan FAST - this will tell you exactly when it was made (what batch)..

They have a black CAS

That's about the only way to visually identify them..

feel like buying some cams off me? :P

I have one aswell. I was curious to why the 40th Anniversary skyline version cost a fair bit if you were to buy one?

Any differences?

Visual differences, they had an optional rear spolier (GTR type) and an optional front bar (again GTR look-a-like) as well as badges.

They also came in limited colours like Midnight Purple Pearl II

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Here is a recipe. Sonic blocks till you get one that has a good enough bore. Get a torque plate and block brace, use your choice of fasteners (arp ect) bolt the thing together empty, half fill it and let it cure. Release it when it has, go to a REPUTABLE RB Builder and get the thing line bored/honed and cylinder honed to size, then wash. Once its all clean and dandy, wash and blow it out again. Then again.  Assemble said engine to your desired clearances with oil control mods, gasket to suit desired CR/Squish ect. Attach your extended sump with proper trap door oil baffles and head drain plumbed to sump with a SUMP BREATHER SYSTEM. Build your front diff with a decent LSD, rebuild your transfer case with a few extra plates, more than likely replace your tailshaft centre bearing and tighten up the rear diff. Tune to minimise excessive midrange cylinder pressure (timing unless you like to split bores and rebuild engines) Enjoy your engine, but hate the fact you are now destroying engine mounts, gearboxes, gearbox mounts, diff output flanges and driveshafts, diff mounts, tailshafts and front CV's.   Disclaimer.... Ive never done any of the aforementioned stuff.......
    • 440s will support well over 400HP on petrol, which is a decent place to be for an RB20. 230+rwkW. Will be a safer bet for idle/low load. 550s would be nice for the extra headroom. I've made the same decision with mine (Neo25). 1000s are probably too big for the Nistuned ECU, so I have some smaller ones.
    • Appreciate everything guys. I did go ahead and get an alignment... most of my complains are solved. Car is not perfect, but it's good enough. If I notice uneven tire wear or anything I'll just take everything back to stock.  Thanks again!
    • They still have not shipped the 550cc injectors as they weren't in stock, so in theory I could ask to get the 440cc ones instead, if those work better in my scenario. They're the same price so really shouldn't be an issue. Unfortunately I am not so knowledgeable in most parts of tuning so I wasn't sure what's best to choose between the two. 440cc ones are the lowest they have (not in stock, but available to buy nonetheless).
×
×
  • Create New...