Jump to content
SAU Community

Official Sauwa Cruise - Perths Most Haunted Places- Oooooooo


Recommended Posts

  • Replies 412
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

hey everyone.. yeah i don't know any of you but i'm hoping to meet you all this friday.. i'll come to the woodvale meet up point.. i don't mean to brag but i do know a LOT of people in perth so maybe you'll all pop up and be like "HEY I KNOW U! " 9pm meet up? i'll be driving a green hyundai excel ^_^ by the way.. you should all seriously exchange phone numbers it works well

and i'll try get some chosen few members down :) cuz im not supporting any club on friday simply why im driving the excel out hehehehe

*edited*

Edited by dan_the_man
ok cool.. and with the UHF ch 18 is that just the little hand held wlakie talkie things???

Yeah you can get full units that fit to your car but hand helds are probably better and easier for this type of thing. I got 4 from dick smith for about $150 or something. I think single is under $50.

Just make sure its UHF band and not AM, or it will be useless to you.

On the the question about the police. I have been on several cruises where they meet at the meet points. Never seen them issue anything. They normally drive around, talk to a few people, have a look around to make sure no one is doing anything silly. As long as its all good, they will leave with no problems at all. Unfortuantly as soon as 1 person does something stupid, they get a bit upset. I think hillarys was different due to the large amount of fools/racecar drivers if you know what i mean.

Yeah you can get full units that fit to your car but hand helds are probably better and easier for this type of thing. I got 4 from dick smith for about $150 or something. I think single is under $50.

Just make sure its UHF band and not AM, or it will be useless to you.

Hey Brad what are you doing with the other 3??? Do you see where I'm going with this!!!??? :P

Hey Brad what are you doing with the other 3??? Do you see where I'm going with this!!!??? :wave:

HA HA i think i can see where your going with this. Im sure if you buy the batteries, i could possibly lend you one.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...