Jump to content
SAU Community

Recommended Posts

Okay,

Went in expecting around 180ish rwhp, as my car was misfiring on 7psi..... *sigh*

Pulled 208.8hp@7psi (not bad for stock boost) with a power curve that looks like a set of stairs....

I gots Zorst (w/front pipe), POD, Cold Air, and stock boost...

after having a chat to steve he commented that the timing was retarded a bit, and suggested i advance it a bit for more power... what a difference that made! was able to up the boost to 11psi, no misfiring at all, and the power pulled all the way to redline... DAM.. Kym wants another run!!!!!!

Thanks for the advice steve, i'll be back to tune the new AFC and EBC real soon...

-Kym

edit - Mod :don't forget the no cat kymbo which gives about 10-15 at the rears from the cars i've seen with it and without it.

Link to comment
https://www.sau.com.au/forums/topic/18310-sst-dyno-day-post-your-results-mods/
Share on other sites

  • Replies 83
  • Created
  • Last Reply

Top Posters In This Topic

I hate to steal their thunder.....but :D

There were 2 manual NA RB30's R31's both around 135rwHP

And a very sweet lookin Manual RB20DET GTS-X which put down 137rwHP

I think my wagon was a off the pace due to being auto...manuals were held in 4th, my auto was in 2nd I believe. :O

Originally posted by adam 32

strich9: so your car was misifiring cos the timing was retarded?  

what revs was it misfiring at? (i only ask cos ive got a bit of a flat spot at the moment im trying to sort out)

Yep, Sure was Adam. As soon as I cas-bashed it a bit 2mm (on the cas) advance, all the misfiring stopped except for a small pop ord two between 4-5rpm. Immediately the car pulled like a train and I was able to wind the boost all the way up to 11psi. I HAD to run 7psi before or the misfire was really bad...

It also had MAJOR flat spotting before the timing was corrected.

Attached my dyno sheet :D

dynosst.jpg

343.6 at 1.2 bar on std ceremic terbs with boost control going all over the place. No damage done and boost control now sorted (I wound up the boost and left the duty cycle at a default 60% which is way too high compared to what has been "self learnt" for the lower 1.0 bar boost).

Mods: HKS engine pipe, Jap spec cat, HKS Hiper Zaust, PFC with boost kit. Normal boost 1.0 bar delivered 318 hp atw previously.

Mine managed to get itself to 210.2 HP. Got to 198 with nothing tuned then Steve quickly added fuel to my top end which got me to the 210. Will have to get my S-AFCII tuned properly and wind a bit more boost into her. Might help if i make a partion for my HKS pod, damn that thing's noisy.

For mods, see signature. Note: Nothing tuned yet....

Originally posted by S13_Angel

233.7hp @ 12psi

fmic, pod, 3" zorst (turbo back), badbiki.

very impressive angel, no wonder shes such a sleeper

as for me see the sig its got all the info, theres more roomto play but i don't think it would reliable then

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So either way it is gearbox out and look what is wrong?  I know about the input shaft bearing. Even before swap/new clutch the it sounded exactly like this: So is that inout shaft bearing or the other was installed backwards?  And can some please tell me the part number for that input shaft bearing? The gearbox is small box from R34 N/A and number is FS5W71C. Thank you  
    • I am yet to see anyone ever regret a quaife or helical. ...other than drifting/skidpan duties. I kind of want to upgrade my factory helical with a Quaife (but really it's not ultimately that different, and is a MASSIVE UNDERTAKING), that's how good the hype is about them, that I want to try them 'just to see'  
    • D2 and Ksport are essentially the same thing and basically just generic Taiwanese manufacture. Better than ChinaBay crap, but... not top shelf. Öhlins have got to be some of the best dampers around, so likely to be a good option. It's going to get to the point though where I suggest you buy from Oz. We have at least 2x excellent options here. If I were you though, I'd be talking to KW about doing something for the R33. There's bugger all difference between that and the 32. In GTR land, anyway.
    • KW only offers a set for the R32 GTR. Popular options are D2 racing, Ksport or Öhlins. I have a D2 Racing coilover set, though I don't know for sure which one.
    • Well, the good news is you have more than one very good option for new coilovers in and around your country. Worth the drive over to KW to talk about GTR stuff.
×
×
  • Create New...