Jump to content
SAU Community

Recommended Posts

  • Replies 83
  • Created
  • Last Reply

Top Posters In This Topic

Originally posted by Nexus_SiX

Grand total of :269.8RWHP  

This was achieved with a pod; "bush airbox"; 3" from turbo with exhaust wrap and a Power FC

Not forgeting the BOV and 2 SAU stickers

Nice to meet ya too btw.

Originally posted by Steve-SST

We need to Dyno test these stickers.  

You'll have a tough time. Theyre pretty bloody impossible to come across, hey memphis?

If you'd listened to me I could have saved you $25
Originally posted by S13_Angel

PSI GTSII: huh??

I told ya before ya put it on the dyno it'd do 230rwHP;)

I am also quite talented with a 'Crayola Caddy' and could have knocked you up a great dyno graph to:p

Not sure how much credability it would have held though:rolleyes: :D

zanda lol @ 13.1 on stock turbo. not unless your running 20psi

My old Red top T25G SR20 did 228rwHP on 13.3psi.....and ran a low/mid 13 on this setup....with a good 60ft Its 'do able';)

Nice result Matty  

must be a nice streetable package now - swap you a drive when I get back from OS.

Thanks Gav - yeah it's not too bad - the tuning is the secret.

No worries with swapping the drive, hey, if ya need me to look after the R whilst you are away, just drop me a line!

:uh-huh:

Originally posted by zanda

Nice to meet ya too btw.

 

You'll have a tough time. Theyre pretty bloody impossible to come across, hey memphis?

Ohh calm down, I slept in and didnt have time to drop in at the office!

But i do have a heap of them ready to be dropped off at works auto

Also, I hate to see what my car would have got without my 3x SAU stickers :uhh:

nice to see u all - dont think ive seen so many skylines in one place haha. I was too wussie to put my car on - its nothing to get real excited about anyway.

But good job guys must admit there was some surprises in there as well ;)

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...