Jump to content
SAU Community

Recommended Posts

You could probably re-direct that comment to those that have said it is relatively quiet (bar the blitz NUR) on this forum.... maybe they're wrong? I disagree with you on looks though ... the standard has two tips and so does the legalis... now when you consider most rival tips looks like cannons then I'd certainly assert it does look close to stock in comparison.

Yeah, when you give it some, the thing is loud. The nismo I have is pretty much the same. It's not near stock. At low revs, it actually does a good job at keeping things kinda quiet.If you really want an exhaust that is stock quiet and flows, then it's going to be custom.

Yeah, when you give it some, the thing is loud. The nismo I have is pretty much the same. It's not near stock. At low revs, it actually does a good job at keeping things kinda quiet.If you really want an exhaust that is stock quiet and flows, then it's going to be custom.

I don't know what I did above ^^^ (how do you delete a post).

I thought (again from what i've read on here) custom exhaust weren't as quiet as some branded exhaust. If not, i'll just do that, they're cheaper as well eh?

Well, all depends on what you say you want. If you ask of a 1.5inch spaghetti mess, they will give it to you.

Ask for a quiet flowing exhaust with stock noise, and it might cost a bit more, but they will make one.

You in Sydney? You can have my 350z mid pipe that flows a heap better for $80. Larger diameter and just a resonator, instead of that massive muffler.

For pic see

Here

Edited by PN-Mad

I don't know what I did above ^^^ (how do you delete a post).

I thought (again from what i've read on here) custom exhaust weren't as quiet as some branded exhaust. If not, i'll just do that, they're cheaper as well eh?

It's all down to what you ask for and where you take it.

I have a custom AM Performance exhaust. It was a development version, so it was too loud to start with, but it has now been fixed up and is pretty much to my liking. Andrew at AM will sell you an exhaust to whatever volume you'd like. You want a crazy loud one, he will oblige. Quiet? He will oblige.

Mine is reasonably loud when you put the boot in, but doesn't drone on long trips. It also looks sex with twin 3" titanium tiips. Everyone who sees them, loves them. Mmm... titanium...

lol the blitz NuR is quiet.. i got one and you can hardly hear the dam thing.

Mine was like that. Wait a 1000 kms or so & it'll get louder; or more noticeably the note gets deeper.

You could probably re-direct that comment to those that have said it is relatively quiet (bar the blitz NUR) on this forum.... maybe they're wrong? I disagree with you on looks though ... the standard has two tips and so does the legalis... now when you consider most rival tips looks like cannons then I'd certainly assert it does look close to stock in comparison.

Relative to what though?

I owned a Legalis for a couple of years up until last year where it went on Scott's car and the Nismo (same as on Alex's PNM35) went on mine.

Regarding looks, I like both of them, but as you can see in my sig, definitely not stock looking.

Custom exhaust depends on the competence of the maker I guess.

I understand a lot of them come over with only one key .... what did you guys do getting another one? just got another cut ?

Invest in a good alarm & 3 point immobiliser, and get some more keys cut. The blank key (with no buttons) has the part number H0564-AU000, search for it on ebay and you'll find some for around $30 delivered; personally I think thats the easiest option :thumbsup:

Mine was like that. Wait a 1000 kms or so & it'll get louder; or more noticeably the note gets deeper.

ive had mine for around 15-20,000 now. still quiet... but i havent got a dump yet...

ive had mine for around 15-20,000 now. still quiet... but i havent got a dump yet...

Hmm this might be a go'er if the Legalis is loud. I know a dump improves performance significantly (and i'm doing that) but does a cat-back in these cars do much on top of the dump?

Any recommendations for an air filter or is a K&N from autobarn or supercheap good enough.

Upon importation, did most of you get it serviced straight up? Compliance don't do anything along those lines do they?

Hmm this might be a go'er if the Legalis is loud. I know a dump improves performance significantly (and i'm doing that) but does a cat-back in these cars do much on top of the dump?

Any recommendations for an air filter or is a K&N from autobarn or supercheap good enough.

Upon importation, did most of you get it serviced straight up? Compliance don't do anything along those lines do they?

I recommend not getting a pod, but instead using the factory air box, getting a K&N filter or the like, and getting the 'power duct' genuine nissan attachment (part number is somewhere on here)

It's cheaper than a pod and performs just as good if not better and you retain your cold air intake. It also seals to the top of the bonnet too!

I actually got mine serviced after compliance, because the compliance workshop didn't change the fluids. (Idiots)

The key with these things is to change the oil and filter often as per the typical turbo oil replacement schedule.

Luckily with mine the service history was good, so it didn't really need it, but better safe than sorry.

Hmm this might be a go'er if the Legalis is loud. I know a dump improves performance significantly (and i'm doing that) but does a cat-back in these cars do much on top of the dump?

Any recommendations for an air filter or is a K&N from autobarn or supercheap good enough.

Dump should be number 1 priority, for both performance, economy & increasing turbo life. A cat-back does help significantly & you will see what we mean when you look at the factory mufflers, especially the HUGE one in the middle of the car. Weight saving along is worth the upgrade, lol. After that, the mid (front?) pipe can be changed for one with a hi-flow cat & there will be more (but lesser) gains. If you do this, get an exhaust bung for wideband sensor welded in at the same time.

Stick with any off the shelf filter in the factory airbox as suggested above. IMO if you notice a performance gain just by choosing one filter over another, it's purely placebo.

QFM pads are pretty popular around here. I've got HPX pads and no complaints. They're cheap, you can get them through GSL Rallysport, who are a forum sponsor.

AFAIK V35 coilovers will not fit an ARX. I think the rears are different? Plus you'd dump it. What's wrong with BCs?

Just ring GSL Rallysport - I think I had to wait a WHOLE DAY and Greg knows what fits anyway, you'll pretty much just have to tell him you want pads for a M35 Stagea.

As Cam says, they're 350Z Touring, and that's all over the site if you have a search :google:

Oh and the shocks, BC BRs are not universal. No shocks are. I think the fronts would be fine, rears would be different maybe? If they're your sisters just try fitting them and see!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • The rain is the best time to push to the edge of the grip limit. Water lubrication reduces the consumption of rubber without reducing the fun. I take pleasure in driving around the outside of numpties in Audis, WRXs, BRZs, etc, because they get all worried in the wet. They warm up faster than the engine oil does.
    • When they're dead cold, and in the wet, they're not very fun. RE003 are alright, they do harden very quickly and turn into literally $50 Pace tyres.
    • Yeah, I thought that Reedy's video was quite good because he compared old and new (as in, well used and quite new) AD09s, with what is generally considered to be the fast Yokohama in this category (ie, sporty road/track tyres) and a tyre that people might be able to use to extend the comparo out into the space of more expensive European tyres, being the Cup 2. No-one would ever agree that the Cup 2 is a poor tyre - many would suggest that it is close to the very top of the category. And, for them all to come out so close to each other, and for the cheaper tyre in the test to do so well against the others, in some cases being even faster, shows that (good, non-linglong) tyres are reaching a plateau in terms of how good they can get, and they're all sitting on that same plateau. Anyway, on the AD08R, AD09, RS4 that I've had on the car in recent years, I've never had a problem in the cold and wet. SA gets down to 0-10°C in winter. Not so often, but it was only 4°C when I got in the car this morning. Once the tyres are warm (ie, after about 2km), you can start to lay into them. I've never aquaplaned or suffered serious off-corner understeer or anything like that in the wet, that I would not have expected to happen with a more normal tyre. I had some RE003s, and they were shit in the dry, shit in the wet, shit everywhere. I would rate the RS4 and AD0x as being more trustworthy in the wet, once the rubber is warm. Bridgestone should be ashamed of the RE003.
    • This is why I gave the disclaimer about how I drive in the wet which I feel is pretty important. I have heard people think RS4's are horrible in the rain, but I have this feeling they must be driving (or attempting to drive) anywhere close to the grip limit. I legitimately drive at the speed limit/below speed the limit 100% of the time in the rain. More than happy to just commute along at 50kmh behind a train of cars in 5th gear etc. I do agree with you with regards to the temp and the 'quality' of the tyre Dose. Most UHP tyres aren't even up to temperature on the road anyway, even when going mad initial D canyon carving. It would be interesting to see a not-up-to-temp UHP tyre compared against a mere... normal...HP tyre at these temperatures. I don't think you're (or me in this case) is actually picking up grip with an RS4/AD09 on the road relative to something like a RE003 because the RS4/AD09 is not up to temp and the RE003 is closer to it's optimal operating window.
    • Either the bearing has been installed backwards OR the gearbox input shaft bearing is loosey goosey.   When in doubt, just put in a Samsonas in.
×
×
  • Create New...