Jump to content
SAU Community

Recommended Posts

Yesterday around 6:30 saw a black 33 P plater getting on Westal Rd at the springvale end... ...gave a quick wave but I don't think he saw me... ...Think he was Asian with a bit of a light coloured stripe in his hair... ...I think there was a second person in the car... ...Not to sure...

Spotted cr33m at about 1am this morning turning onto Boundary rd heading towards Aspendale gardens about 2 minutes before i got pulled over :down:

Darkish r32? Was it chick cops? They pulled over harsh (Vspect) on boundary rd

saw something that at first glance looked like the same decals as Laith in Hoppers on Fri night but were grey/black ones and probably different.. only got a quick glimpse..

distinctive yellow silvia in Altona and then Hoppers.. stalker

red r33 parked next to me in Werribee on Thurs night... also going to the bottleshop lol

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
    • @Duncan I can try  and thanks i did not thought about VIN and part numbers for 33/34. @GTSBoy yeah it looks like iam gonna do that  
×
×
  • Create New...