Jump to content
SAU Community

Recommended Posts

  • 2 months later...

IN my experience the 32 is just easier to slide lol, mind you anything is easier then the ae86 i drive now, i guess people use 32's more because, they're cheaper, more of them, more options in parts like body kits cos u know a kits inportant to drift with lol, but out of all the cars ive driven my top 3 easiest was, r32, r31 and S13 but even in saying that, it all depends on the setup and the type of driver you are.

Dunno if that helps but yeh.

Edited by stefan.o
  • 7 months later...

what i dont get is how people dont drift them due to size and weight issues - its weird if the japanese think this aswell as they absolutely love cefiros, jzx100 etc etc

if a big old cefiro family car can slide well why not an r33...

btw great thread keep updating with pics/ vids

  • 5 months later...

What about the JMS R33 drifter that became Mark Phillips ppg then martini drift car? That car was mental. I remember the first time i went to a drift event at Mallala I saw that 33 tearing up the main straight. That car was awsome

they were good times and dont forget port gawler lol

  • Like 1
  • 1 month later...

Ceffies and Jxz100s are both smaller and lighter than an R33.

The 33 does has plenty of potential though as shown by the pics/vids above

A chaser lighter than a 33..hmmmm.

Toyota Chaser 2.5i Tv^in-turbo 24V photos

Type : L

Doors : 4

Places : 5

Disposition of cylinders : R6

Disposition of engine : Fl

Volume : 2491

Diameter of cylinder : 86,0 x 71,5

Degree of compression : 8.5

Valves : 4

Disposition of shaft : dohc

Power supply system : EM

Pressurization : TA

Power PS (kW) : 280(206)/6200

Torque : 363/4800

Type of drive : H

Transmission manual : 5

Transmission automatic : 4

Front suspension : QL.FB,QS

Rear suspension : ML,SF,QS

Hydro : +

Break : Si/S

ABS : +

Tyre pressures : 205/55 R 16 V

Wheelbase, mm : 2730

Track : 1485/1495

Size Length x Width x Height: 4750 x 1750 x 1390

Mass equipped : 1450

Mass full : 1725

Volume of trunk : n.a.

Mass of trailer : n.a.

Volume of tank : 70

Dispersial 0-100 km/h : n.a.

Max speed : n.a

Cost of fuel 100 km : 8,5

Fuel : Sb

  • Nope 1
  • 4 weeks later...

lol all you guys that have experienced all the different chassis and models are lucky...

i ha ve to say r33 is easy to drift but thats comparing to my old cars, a vx with a spool and a volvo 360 glt..... the 33 was amazing haha

would love to try an s chassis if what everyone says is true..

i think the long wheel base makes it more fun

Edited by PaulosECR33

, My r33 is built for drifting, its got all the basics, 2-way diff, pinapples, 255kws,9point cusco saftey 21 cage, big fat rims 18x10's with phat offset..

I think r33's are good for drifting, its the way you drift, your style.

here are some videos of me drifting at winton.

and some photos

111210t.jpg

Uploaded with ImageShack.us

995798213qs28cl.jpg

Uploaded with ImageShack.us

geraus.jpg

Uploaded with ImageShack.us

Edited by geraus

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
    • I checked spark on all cylinders and they all visually have spark with the plug pulled and grounded, but plug 1 is the only one that fouled. This was a running swap that blew up and was rebuilt by a machine shop, put a new wiring specialties harness and did all gaskets, studs, and bolts while it was out.  compression is 135-150 across all cylinders. Aside from that from my understanding with the z32 ecu and maf the car should start regardless. The wiring for TPS and the dual 02 sensor/ dual knock sensor stuff shouldn’t actually stop the car from starting or even running well, (just slightly rich)  they just give fault codes. Car supposedly is supposed to start as long as you have z32 afm and ecu with the nistune base map and that’s info coming from a well known and trusted tuner who does a lot with SR/RB (Rsenthalpy). After more trouble shooting today where I’m at right now is that the cas is sending signal to the injectors they click while spinning the rotor, Fuel pressure is now set at 43psi, all cylinders have good compression and all of the plugs looked great (just wet with fuel) except for cylinder 1 which was very black (cylinder 1 has 150psi compression). all of the coils generate spark if pulled out and grounded out on the head. On the fuel pump car just pops into the exhaust. On starting fluid car will fire off. Hard to tell if all cylinders are firing off but definitley a couple. sounds like all of them but it’s only for 3-5 seconds hard to tell. 
×
×
  • Create New...