Jump to content
SAU Community

Recommended Posts

Yep, it was actually built by Racingline. I gave it to Ice but they split before they got started and it was finished by Nigel and Karl at Racingline.

It is now owned by another forum member.

I live right next door to the Daily Planet lol

  • Replies 219
  • Created
  • Last Reply

Top Posters In This Topic

Aiming to get back to the dyno the weekend (or Friday) after the easter long weekend.

Guilt, will you be free sometime around then?

I want to wind the boost up from 17PSi to 19PSi also. Hopefully then with a bit more boost and the hi flow cat, it will crank out ~300AWKW.

It will be interesting to get a power run done on a Sydney Dyno down the track to compare results.

+1 for pepe's avatar.. :)

What other body parts did she flash you?

Sorry to get off topic here, but until there is more information about Bakes's build the boobies have caught my attention!

Aiming to get back to the dyno the weekend (or Friday) after the easter long weekend.

Guilt, will you be free sometime around then?

I want to wind the boost up from 17PSi to 19PSi also. Hopefully then with a bit more boost and the hi flow cat, it will crank out ~300AWKW.

It will be interesting to get a power run done on a Sydney Dyno down the track to compare results.

yeah mate, you know the score, whenever you are ready!

you should get the shirt man to finish that timing belt first though imo

yeah mate, you know the score, whenever you are ready!

you should get the shirt man to finish that timing belt first though imo

Did he forget to tighten another one? LOL LOL

Just kidding Bakes i am sure it will be fine.

  • 2 weeks later...

Guys if you have a look at this post, it appears a "before" power figure was known (late December 2008);

Im starting to collect parts now for my goal of ~320AWKW.

My R34 GTR was stock when I bought it, I have installed the following:

* Exhaust: HKS Front pipe and Cat Back with Hi Power Muffler.

* Fuel: Nismo Fuel Pump and Fuel Pressure Regulator.

* Control: HKS EVC 6 Boost Controller

* Intake: HKS SPL Piping Kit with Super Flow Pod Filters.

Current Power: 240AWKW at 1.2 Bar

When was the compliance cat discovered? Quite strange to change the front pipes and the cat back without doing cat at the same time, even so, if it was a POS cat, surely any decent exhaust shop wouldve mentioned it when the car was picked up so it could be fixed in the future, or even right then if they were trying to get some more money out of the job at that time.

Very suprised it has a restrictive cat if what Bakes posted in that above post was correct.

Well Bakes, good luck with it :thumbsup:

Guys if you have a look at this post, it appears a "before" power figure was known (late December 2008);

When was the compliance cat discovered? Quite strange to change the front pipes and the cat back without doing cat at the same time, even so, if it was a POS cat, surely any decent exhaust shop wouldve mentioned it when the car was picked up so it could be fixed in the future, or even right then if they were trying to get some more money out of the job at that time.

Very suprised it has a restrictive cat if what Bakes posted in that above post was correct.

Well Bakes, good luck with it :)

Car came from Japan with HKS front pipe and HKS rear pipe with Hi Power Muffler and with stock or compliance cat. I wasnt aware it was the stock cat at the time I typed the old info.

Some body probably forgot to take the rag out of the inlet when they had the engine apart to keep all the dirt and crap out and that is what the problem is .

Dont laugh , I've seen it done before .

im my defence i was on my 16th beer and it was only a mates gtr

lol

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I’m not sure what happened I told them about sonic tunes free OTS tune and the next the I know .. I was booted..   To funny 
    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
×
×
  • Create New...