Jump to content
SAU Community

Recommended Posts

yeh thats them they called that gtir rwd-r

also did a full mines response r34 gtr awsome car that was

Yeah, that's Sasha (Japboyz). You'll find his workshop no longer exists, as he got out of the game. Between him and Chris (the MINES R34 owner, and the guy that imports most of Autostyles cars), they have some damn nice stuff... :( The Escorts are sold as well...

I regret to say that dog is no longer - got run over by a car ;):D

SPotted a white 32 t. on walgrove road today.. I thinka chick was driving it.. it was really clean! :( Any ideas?

I think that was BWA :P

Lucky girl! You've only had the car for 3 days and you've been spotted already. It took me months before I got spotted.

Spotted 2x Gunmetal Grey R32's in Hornsby.

(Missed plates)

Saw a grey R33 GTST Type II also in Hornsby.. Plates were WQF-3??

hmm...I have an R33 GTST but series 1 with series 2 wing....not my plates though but im always around Hornsby in it!

where and what time?

Spotted Dragon yesteday morning again

<_<

ugly spinners and a kermit green paint job

Yer i spotted him at UAS a few weeks ago... Not a real fan of the spinners :P

spotted LIZ (Miss Turbo), jeff (jeff33r) and john (flukey) at homebush just then, LOL nice meet up guys... hehe shame it wasnt earlier could of went for a nice cruise...

Edited by mass_iv
Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Update: tested my spark plugs that are supposed to be 5ohms with a 10% deviation and one gave me a 0 ohms reading and the rest were 3.9ohm<, so one bad and the others on their way out.
    • 9" wheels are a little too wide for a RWD 32. They can fit. People have put R33 GTR wheels on 32s for years and years. But they are a very tight squeeze. This has been known for about 30 years. As I said - there is no difference between a 17 and an 18 in terms of what will fit. The rolling diameter needs to stay about the same as stock - not very much larger. If you increase that, you will start to have problems. If you increae rolling diamater at the same time as yo increase width, you will have problems earlier. as 9" wheels are pushing the boundaries already, you would need to be careful with tyre choice. I would put 8.5s on the front of mine, but would expect problems with 9s.
    • post up screen shots of your injector tables
    • Diagnostic flow for a code 21 says check signal at the ECU pins, on a voltmeter of some kind it should read 0.1V at idle, 0.12V cranking, 0.15-0.25V at 2000 rpm. Check each coil such that +1, -3 is infinite or very high resistance, -3, +2 should do the same. (-1, +3), (+3, -2), (+1, -2), and (-1, +2) should all be somewhere between 0 ohms and high resistance. If you trace the path from the coil pin all the way back to the ECU in the diagram the resistance you measure at the coil vs connected to the harness should be pretty much the same. 
    • I have an elite 2500 running an adapter harness on an rb25de neo r34. I took the butterfly out and removed all that junk. But I also went Plus+t at the same time. The butterfly thing works in reverse to the boost solenoid on the Gtt if that makes sense
×
×
  • Create New...