Jump to content
SAU Community

Recommended Posts

not as bad as the V35 SEDAN that had knock off GTR badges on both front quarters when I was filling up at the servo the other day, I was two rows over & you could still tell they were a cheapo ebay item too small & too red on the "R" it was like a neon red lulz

ahh was that v35 white? If so it was about 500kw and was built before nissan got around to doing the r35.....

i think I know which one you are talking about, it was at one of the sydney autosalons from memory didn't know the white one was a sedan though :D

no, this thing was a bog stock V35 silver sedan :P with knock off GTR badges on the two front quarters :P probably would've seen a dirty big one on the back had I not turned my head away in disgust

Spotted RJ (R 2 The J) and his 33 at thornleigh maccas, thanks for the bov should be on soon :D

and also a nice black 34 gtst very clean driving up pennant hills rd then at maccas you went into the drive through. JAY-XXX????

I was in the black stagea :)

white R33 s2 with standard yellow plates running up my arse on the M4 yesterday

then proceeded to cut through lanes of traffic to get ahead only for me to catch up anyway by the time you hit the servo/maccas after the blacktown exit

well done @ssbag, don't you know its DD's?

not as bad as the V35 SEDAN that had knock off GTR badges on both front quarters when I was filling up at the servo the other day, I was two rows over & you could still tell they were a cheapo ebay item too small & too red on the "R" it was like a neon red lulz

Man I spotted this car today too and yes it did have one on the back too lmao!

Saw these in Thailand, I think the Tuk Tuk was epic, it was all pimped out with R33 tail lights, exhaust, Massive sound system and assortment of led's and black lights....

did anyone notice the 2JZGTE engine and turbo on the boat???? DAmmit ive just zoomed into the pic now at home and i realise the potential that shack boat might have had, from a distance i didnt notice what engine it was :blush:

But still wtf? on a boat? I only saw one supra in Bangkok city...

post-53255-1262694982_thumb.jpg

post-53255-1262695066_thumb.jpg

post-53255-1262695104_thumb.jpg

post-53255-1262695168_thumb.jpg

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Have you done the Ignition Sync Wizard in the AEM software?
    • Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
    • I don't know any details, but I really wouldn't be surprised if they do it as a LHD only version, at least initially.
×
×
  • Create New...