Jump to content
SAU Community

Recommended Posts

I think i spotted Zeebs on Sunday, about 3pm near the square.

I was turning onto Narellan road and you were stopped at the lights going straight onto blaxland road.

Tried to give you a wave but i don't think you saw me?

Your 34 looks hot with the LM GT2's. Very chunky from the rear, great presence.

Spotted a silver R33, number plates "GOD xxx". Girl driver :wub: on Church St turning onto Victoria Rd, Parramatta.

Both gave it a little squirt around the corner in 1st gear before she turned off.

Edited by EurasiaN!

Just sppotted a maroon 33 & black 33 (I think) coming up pennant street in castle hill. Just 5 mims ago

Sounds like me and my mate coming back from work, finally spotted!! haha ive got the red 33 :)

Just sppotted a maroon 33 & black 33 (I think) coming up pennant street in castle hill. Just 5 mims ago

Sounds like me and my mate coming back from work, finally spotted!! haha ive got the red 33 :)

and ive got the black 33 hehehehe ;)

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...