Jump to content
SAU Community

Recommended Posts

need an answer to this quick:

Took my car to Beaurepairs to get my front wheels balanced! they finished and when I went out the guy tells me that one of my $250 kics nuts has been threaded and same as the stud on the spacer. Is there anything I can do? He told me they were hard to get off so he had to get them off by hand and it was f**ked already....

do NOT accept this.

look for signs of scratching on the nuts and see if they used the gun and then call head office and complain

tell them you EXPLICITLY directed them not to use a rattle the gun and they did due to nothing but laziness.

you want a new set of kics nuts or the $350 (retail) to replace them. also a new stud or spacershould be paid for

just go HARD

annoying knocking noise coming from one of the rear coilovers what does that mean? no leaks as far as i can see...

chek your bushes? Mine made knocking noises from the front due to worn rosejointed bushes

annoying knocking noise coming from one of the rear coilovers what does that mean? no leaks as far as i can see...

Give the tops and crack with a spanner.

Do you have a rear strut bar? That could have come loose.

Wheel nuts..

chek your bushes? Mine made knocking noises from the front due to worn rosejointed bushes

hmmmz

Give the tops and crack with a spanner.

Do you have a rear strut bar? That could have come loose.

Wheel nuts..

you mean tighten the tops? they are..

no rear strut bar

wheel nuts are fine

old coilovers were a bit noisy but that was coz i had removed the helper springs and compressed the springs. these HKS ones are louder

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • I’m not sure what happened I told them about sonic tunes free OTS tune and the next the I know .. I was booted..   To funny 
    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
×
×
  • Create New...