Jump to content
SAU Community

Recommended Posts

I've done lots of searching both here and on other forums so I apologise in advance if the correct answer is out there.

So far I've found quotes that the standard R34GTT NEO injectors are 340cc,350cc,370cc or 380cc.

Can anyone say for certain what size they are? I think that I might be reaching the limit of mine as I have injector duration of 20-22m/s at full throttle.

My S2 Stagea is running FMIC, std turbo (soon to be replaced with hybrid) 80mm cat back,silenced decat,apexi induction kit, Gizzmo EBC set at 0.75bar boost and Walbro 255lph fuel pump.

Edited by DeanR33
Link to comment
https://www.sau.com.au/forums/topic/324899-r34-gtt-std-injector-size-please/
Share on other sites

well the r33 injectors are 370cc and from what i am aware the r34 is the same size (not 100% sure on that though).

if you are reaching the limit of the injectors with only 11psi then there is something going on. either your fuel pump is stuffed, fuel filter is blocked or the fuel pressure reg is stuffed. not sure what 20ms is in % of injector duty. generally about 250kw is the max for stock injectors.

I'm maxing out my nismo 480cc's at 240kw, so i'm pretty sure my stock 370cc injectors would not have got that far...

Yes 34 is definetly 370cc!

There's definitely been people on this forum finding 220rwkw on the standard 370cc, but I'd understood that was the limit without increasing the base fuel pressure. I'd also always understood the nismo 480cc injectors to be roughly good for 480hp at the engine and 280+rwkw?

(480hp = 357.9kw .. take 20% drivetrain loss - 286.32rwkw)

Can anyone else confirm their experiences?

I always thought that they were 370 or 380cc, but I posed the same question on Skylineowners.com and someone on there swears that they are either 330 or 340cc, which amazes me considering the regular rb25det ones are known to be 370cc.

If they are 330cc then I must be getting pretty close to needing uprated ones.

To be honest with all the knowledge on here I thought someone would be able to give a definate answer.

Curious as to what these are worth second hand?

And I have read that the nismo 480cc running around 280rwkw on safe tunes in the power thread. Well I hope that is the case as that's what I have bought to support my GT3071R upgrade :thumbsup:

Well, i had these 480cc's running with my original turbo, then when i upgraded to a hks 2835 my tuner said they was my limiting factor for not pushing more boost through (only tuned to 13psi)....

chrisr34gtt that was pretty much the reason i got them too, i was aiming for the 280kw mark and thought it would be achievable with those injectors. Will now have to fork out for new ones if i want an increase! :P

  • 3 years later...
  • 2 weeks later...

The GTR's run 11mm top Orings, and a square large lower Oring. They won't fit without some buchery. What are you after size wise?

The NEO injectors were carried over into the VQ25det's also, as they are exactly the same.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I'm thinking that this is such a small part of the problem that you could easily forego the vac pump and just achieve 90% of what you need, which is keeping the gate open when off boost. It's not as if there are not already techniques to keep a gate fully closed under boost. After all, you have boost. Just use a wastegate actuator that will allow you to apply the boost on the appropriate side, just like every external gate out there.
    • Heres another fitment photo. redrilled the pattern to 5x112, and threw my audi´s rims on. had to touch the upper control arms with grinder, because the "sharp corner" was sticking about 2-3mm on the tire path. i have the "fender lip" mostly cut off, otherwise these (too) would contact with it. 20x9.5 ET25 rear    265/30 20x8.5 ET20 front    255/30 they are temporary, and look too big for the chassis. searching for 19s to it.
    • From experience, it will come back to bite you haha.
    • Background: my BMW 225i hatchback (rebodied MINI/X1) came with 3x RE003 and 1x Goodyear Asymmetric something. The RE003 roared and slid around, the Goodyear side was quiet and grippy. Definitely my car was thrashed before it got sent to dealers. My brother also got RE003 all round on his old VA WRX STI, I wasn't impressed with them, car was loud so can't comment on noise. Anyway, Hankook stopped making/updating V12 Evo2. So bought S1 Evo3 runflats. Great daily duties tyre and not that harsh ride. Tyre reviews site/youtube rated them as best stopping in the rain and I believe them. Next set, Goodyear Asymmetric 5 non-RFT. It beat PS4 in tests and is like $100 cheaper, so put them on. Great tyre, more grip then S1 Evo3 but a tad noisier as expected, still rocking them. Next set I am looking to go runflats, probably the new Hankook Evo. Although the new Pirelli PZ5 did well in tyrereviews test. Or go Goodyear Asymmetric 6 which was top tyre last year. The V12 Evo2 on my gen5 Liberty GT wagon did great in cold condition (drove to snowy mountains for a day so my husky can feel his ancestor's roots). Super impressive performance for $120 each lol. Never skimp on tyres, brakes, suspension. There's old pics of my R31's crappy random brake pads bending in the caliper at Oran Park track day somewhere around here. Anyway, my 2 cents.
×
×
  • Create New...