Jump to content
SAU Community

Recommended Posts

EDIT COMPLETE, here's my consumption

And I didn't drive it like a grandma. Keep in mind I said standard....so it was 190rwkw with standard everything except for FMIC, pod filter, JJR coilpacks, and 11psi

post-60560-0-23881400-1294225085_thumb.jpg

  • Replies 48
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

well atm i have had them for year. car idles fine, cold start always been good, makes 282rwkw on 15psi

mind u thats on a rich (11.5afr) e85 tune! re tune in a week or two for 25psi.

What Ive heard is it all depends on who does it. If they do a good job then it should be fine but also if its dodgy can be a disaster. Ive even heard of some guys freind doing it for him in hes own garage and aparently no complaints lol.

But personally I like to spend the extra and know 100percent I know what is in there is quality so in my book nismos ftw,

I just picked up from the guys at PRO-RACE a set of seimens 650cc injectors $492 ret, a top feed rail $290 ret, and a set if injector plugs from Coventrys $50 ret. I think its the cheapest way and its all brand new so you should not have any problems.

I'm personally not a fan of hi-flowed injectors, probably from one bad experience. A friend of mine had hi-flowed injectors on his 200SX and no matter what I did on the PowerFC I couldn't get A/F on idle or light cruise.

I suspect bad spray pattern, yes it will flow what you want, but it's pretty much acting like a hose spraying petrol instead of misting it.

Please note, I said from "bad experience".

i got my injectors hi-flowed by PJ Quick bits.

600cc @ 43psi

850cc @ 60psi

all flowed within 1-2cc of each other.

no issues yet with run in tune, pulled around 180rwkw @ 8psi, full tune in 1.5wks so i will report back with any issues.

I also had a set done by cef1ie and found them to work fine. Later sold them to another member and never heard back on a complaint. Cef1ie also ran the same thing in his own car to great results.

In the end I got a set of injectors back with one hole rather than 4, so it seems consistent with what was mentioned in the thread above.

ive got 740cc hi flowed injectors, not long after installing them my car developed a bad misfire from idle to 2000rpm, turned out to be inferior quality pindle caps fitted when they were high flowed, quite annoying that a 2c part ended up costing quite a bit in labour to have fixed.

my mechanic isnt a big fan of the high flows, as mentioned he reckons that when they are high flowed the spray pattern is pretty much wrecked. Idle and cold start isnt the best either, once its warm though its fine, apart from that though they do the job.

car is 214rwkw@10psi

Edited by bsd-gtst

i spoke to cef1ie and he said he doesnt touch the pindle at all just the screen so incorrect fitted pindle caps is a load of s*** so in saying that the spray pattern is not changed because the pindle is not touched

Edited by luvpsi

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
    • You haven't driven many modern cars then have you? Most of them have sfa steering feel with their stupid electric bullshit steering systems.
×
×
  • Create New...