Jump to content
SAU Community

Recommended Posts

  • Replies 482
  • Created
  • Last Reply

Top Posters In This Topic

seen a few white s1 and s2 stags over the last week.

1 was in the city on wellington street around 8pm or so

1 was coming off the graham farmer freeway on to grate eastern hwy at about 6 30 or so (S2stag)

and the last was just after the tunnel at the east parade exit at about 4 20 pm ( looked like a 260rs ) but was driving so not really see that well

Happy New year to all,

will have a Meet soon ,it will be heading south,

Big jim is sorting a run out,

The JDM run is coming up to so hope few can turnup,

Cheer`s Chuckie.

Ps Dash Mats ready in week or 2,so them wanting please PM.

got offered the opportunity to possibly be featured in hpi along with jash's rb315 stagea as jash is writing an article on how to build the "perfect" (eye of the beholder i think) stagea

Nice one for the the feature... also keen to get more info on Ash's stag after reading PI..

Also, any weekend with enough notice.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • neither stumble or cut really seem to be an appropriate term....hard to explain its like a rev limiter but at 4k, but it violently shakes engine and entire vehicle as the rpms will not rise over 4k, even with slow acceleration. as soon as it hits 4k, it sounds like entire spark is lost entirely. plugs were 1.1 which I used as such, but later put in new plugs gapped down to .8 changed back after issue arose when I replaced the coils, still does it with either plug gap...damn and it was all running so good.
    • Oh how times have changed! I actually lean it out relative to my water/methanol injector duty cycle. The methanol adds a lot of fueling and you can then lean it out even more due to reduced knock. 
    • Yeah my thoughts are the same, a well thought out WMI setup, would be slightly ahead of just straight E85 and you're also chemically intercooling the charged air, dropping it even further. This is why you need to add so much more fuel as soon as you spray. I remember someone taking me through their set up before (Dennis, has a R33, lives around Cabramatta - no idea if he's still around on this forum). He would target AFR 10:1 on 98, then as WMI ramped on, AFR would lean back up to 11:1. Amazingly, he did this all through his PowerFC, a relay to cut power to his EBC solenoid if there was not enough line pressure on his WMI kit. And of course, if there wasn't any boost made above gate pressure, you wouldn't be accessing the load cells with heaps of timing for WMI. One downside to that rudimentary setup, once the WMI came on, the EBC would unleash the dragon, and of course all the timing. Tyres would fry lol.
    • Shimmed or shimless, still solid, no hydraulic pump up stuff.
    • They have said food will be limited. Mainly meat pies and sausage rolls from memory. But they have a coffee van!
×
×
  • Create New...