Jump to content
SAU Community

Recommended Posts

  • 4 weeks later...

Mitchell's Pass Rd from Blaxland down to Emu Plains has just been reopened since the rockfall of 2009 :)

And they've made it a 40km/h zone.

I could now get busted for speeding on my pushbike.

Well, at least down to Lennox Bridge, one has to scan the speedo...

I don't trust the constabulary not to set up a sneaky trap at the sweeping righthander at the bottom.

At least it's open though, can't complain too much.

  • 1 month later...

Hi all

First great drive is from Thredbo to Khancoban along the Alpine Way then about 5ks after Khancoban turn right up to Cabramurra, through Kiandra and then a high speed drive to Cooma.

Second is from Dungog to the Buckets Way, turn left to Gloucester and on to Walcha along Thunderbolts way, across to Dorrigo then Waterfalls Way down to the coast via Belligen.

Third, The Putty road from Bulga to the halfway house and back.

But the ultimate is Targa Tasmania.

Safety Fast please.

  • 2 weeks later...

Thanks, good info...

A few of us on the Chocolate Cruise did the Mtchell's Pass loop yesterday.

Nice short ONE WAY strip from the bridge to the carpark at the bottom. No speed signs by Penrith Council or Dept of Roads up yet in that section yet.

  • 2 months later...

Terry, my neighbours grandson has only had his licence for a few months, drives a hyundai getz and is no way a car enthusiast or lead foot driver got pulled over at the bottom of mitchells pass at the carpark area and was done for doing 60 something in an alleged 40 zone, i never do 40 on my bianchi down there, but then again i dont want to add wear and tear to my brakes. i took the liberty down the other day and tried to do 40 down the second section it was difficult, may i say near impossible. so unfortunately i just avoid driving the car down there now. :unsure:

  • 2 weeks later...

Police cannot plant themselves on those bends of Mitchell's Pass as you can patently tell.

They'd have to be in the carpark and by the time we come to the last bend, we've slowed down!

He must have got pinged for entering the carpark too quickly!

Police cannot plant themselves on those bends of Mitchell's Pass as you can patently tell.

They'd have to be in the carpark and by the time we come to the last bend, we've slowed down!

He must have got pinged for entering the carpark too quickly!

I've heard that the rozzers have been walking up from the old GWH (behind the locked gate) below the straight section, and getting people with a handheld gun coming down to the left hander just before the final straight section. They then pull you up as you exit onto the GWH.

As has been mentioned; it's now a 40 km/h zone & since it has been closed & reopened, I've noticed a lot more cyclists riding UP; which could get very ugly if a car was moving fast.

I'll admit to going quite quickly down there in the past, but be aware there are a lot more cyclist than I've seen before.

Thanks for the feedback fellahs.

Forewarned is forearmed even though I came down there again this morning. I hadn't noticed any 40Km sign below Lennox Bridge yet.

Hate to get pinged doing 72 in a 40 zone gulp.

  • 5 weeks later...
  • 9 months later...

GOD12A, on 03 Sept 2011 - 18:59, said:

Heya all smile.gif

I drove to Jenolan Caves yesterday for a caving trip and took the GTR out as I remember the roads being kinda fun. Well damn was I right!!

Jenolan Caves Rd from the Great Western Highway is awesome. Very open, easy to drive at speed with relative safety and the roads aren't that bad at all (I run TEIN Super Streets on 18s)

It's a big boring drive along the highway to get there, but for a nice day trip with the missus, I strongly suggest taking the 'fast car' out for a blat wink.gif

Also, Hawkesbury Rd at Yarramundi. My fave local hillclimb!! I've never had a car stick with me, even when I had the bridgeport RX3, and the GTR is even faster up there. Willing to accept any challengers smile.gif

Mark!!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drive beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
×
×
  • Create New...