Jump to content
SAU Community

Recommended Posts

  • Replies 436
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

looks like the we couldnt have asked for better weather tomorrow.

just want to know if we can leave during the day and get back in? asking as i will probably need to fill the bike up at some stage

all five of my spectator passes will be available for others too

Brett, that's the last list I have as @ 12th Sept. It has been an absolute nightmare because of the reschedule and the way we have had to register details with Sydney Dragway.

Please let your Driver know to grab your ticket from the "reserve pool" when he signs up or else come and grab one. Sorry mate, just a logistical headache trying to sort out the last minute details.

As per above folks, the spectator list is locked in. It is just too hard to make the last minute changes. Please have him note that he is replacing Zdravko when checking in.

Sorry folks but having WSID limit the number of spectators has made the whole process really difficult.

Please read my thread on how we will handle spectators from here on out.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Hopefully it ends up being something manageable, like a hone, rather than a full bore—it would be a huge relief if it’s not as bad as it looks. Hang in there; these setbacks are annoying, but it sounds like you’re handling it as smartly as possible.
    • At the end of the day, it’s all about understanding the odds and being comfortable with the potential cost, whether it’s horsepower on a build or chips on a roulette table. And I have to say, the Laine example made me laugh—some people really do embrace that carefree, “roll and see” attitude!
    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
×
×
  • Create New...