Jump to content
SAU Community

Recommended Posts

If you get desperate and feel like driving over east you can borrow mine :thumbsup:

EDIT: aren't us eastsiders a good bunch haha

Yeah whilst you give him the solenoid and make him a drink. I will put his car on bricks and take his wheels :ninja:

Tony, does it go from 5psi to 7psi?

Billy, PM John Aja ssxRicho, I think he have couple from his wreck(s)

Yeah. Though actually better get them off Rick or John though, not sure where mine is in the garage atm.

Just buy one already...

Clicky

Was looking at that one for a while...glad I didn't buy it because the engine popped and he dropped the price to about 18.5k...now rebuilding the engine himself and has put the price back up again.

Just buy one already...

Clicky

Was looking at that one for a while...glad I didn't buy it because the engine popped and he dropped the price to about 18.5k...now rebuilding the engine himself and has put the price back up again.

on the way home was thinking either a low'ish K FD or a high'ish K M3 the way i see it they'll both probably end up being money pits and cost about the same to maintain etc

hopefully this dude buys my car then whatever comes up first i'll probably grab

6-8 x 4

no spotter

drove next to a red FD on the way home, they sit pretty nice and low :dry:

Many lolz I have had benching with no spotter and getting stuck

+ 1 on the FD. But either way can't lose if your other option is an M3.

Any exciting car is going to end up a money pit. You either buy an every-man-and-his-dog Commodore/Falcon and enjoy the cheap parts and reliability, or buy a real sports car and fork out for it - but catch peoples looks when you drive past.

That said, I'd take an FD over an M3 as far as money pit status goes. 13B and RX7 bits can be found everywhere...that M3 engine pops and you're in strife!

Many lolz I have had benching with no spotter and getting stuck

+ 1 on the FD. But either way can't lose if your other option is an M3.

hahah sometimes i spot for my brother or his mate but instead i just stand there watching them suffer ^^,

Any exciting car is going to end up a money pit. You either buy an every-man-and-his-dog Commodore/Falcon and enjoy the cheap parts and reliability, or buy a real sports car and fork out for it - but catch peoples looks when you drive past.

That said, I'd take an FD over an M3 as far as money pit status goes. 13B and RX7 bits can be found everywhere...that M3 engine pops and you're in strife!

by the time an m3 engine pops the rotor would've most likely popped 3 or 4 times lol

just going by what i hear/read rotors are trouble but yeah...

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Hi. Sry iam not a mechanic and iam not at the car atm so i dont know 100% but they told they measure those and even try to change those. AFM they have two. Coils are new a they have my old one too. Plugs too. ECU...we have 25 NEO stock and Nistune 25 NEO.   But i dont know if any one those could be the problem and why/if/what can cause this, Only thing they did not check is fuel...but that walbro 255 is new(like 1,5 years)... That fuel pressure gauge idk...but i let them know Any suggestions?   EDIT: how can they know if it is like you say he ECU pull power when it reaches a specific boost level that is too high? Tha car has boost controler
    • Can you clarify what you mean by boost cut, do you mean it misfires both when under load (driving) and when stationary and out of gear? Or does the ECU pull power when it reaches a specific boost level that is too high (boost control issue)? Does it occur at idle with no throttle? When you say "the ECU is OK", what ECU is it and why do you think it is OK? Have you used the NEO ECU, and if so do you have a MAP sensor attached? Same for the AFM, why do you think it is OK? Do you have any way to put a fuel pressure gauge on it (even just a mechanical one between the fuel filter and fuel rail)?
    • Hi.. Just another problem. So maybe you can help. I(my mechanic) done swap from my RB20DE NEO to RB25DET NEO. Everything is OK but we have a boost cut. Coils/Plugs are ok...AFM is ok. ECU is ok. I have Walbro 255 but it "changed" sound few months ago(you can hear it ouside) you did not hear that when it was new(maybe faulty?) Sooo...what now? What can cause this boost cut? It is even when you standing still...
×
×
  • Create New...