Jump to content
SAU Community

Recommended Posts

Calder was pretty crap last night, got there at like 7 and only got 2 runs until 12.. (with a small dinner break).. around 300 cars there. First run was complete shait, left it in full auto performance mode with traction control off and span 1st 2nd 3rd off the line drifting next to the wall with a 2.7 60ft just let off.. 2nd run was a bit better 13.2 but hit limiter in 1st to 2nd which would of cost me that 12.

Until next time! will definitely be heathcote though. Less cars ftw. Probably enter in that tri battle thing - Ash you going??

Also met Grant down there in his R with a slipping clutch from looks of things :P

Not bad straight out the box!

Yeah pretty quick for stock I guess, I know it has 12 potential but just need more than 2 runs in my GTR I had like 10-12 runs and the last run was the quickest pretty much gained .3-.4 sec over the day. Probably should of taken some air out of the 19s and got rid of spare tyre but cbfed also had like halfa tank of fuel. Really want to get into the 12s at the SAU tri battle now :D

lol yeah that's fair quick for a standard car. Should get a sticker that says "bought not built" :D

Haha, the car would probably get keyed by a holden driver. I must admit its good not worrying about cops. I even did a few laps of prinny last night with racing numbers all over the car and burnt rubber on the rear guards.

Still not happy on the fact that fancy ford with warranty and reversing camera is faster than the mighty mythical japanese creature... tongue.gif

Time to whack Nismo Coppermix twin and milk some more power out of this thing. Smelt some burning on way home but no slippage, should be fine if I simply potter around the town.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • I thought it could be an issue because the standard plate was flexing when stressed. Maybe the original gear set will hold a bit better without flex? Last time on the dyno it made around 670nm at the hubs. Now it have bigger turbo and better intake but have not been on a dyno yet. The car is being used from family trips to drag race events. So the shifts can be a little violent. It is grinding if I shift to fast so was thinking I should overhaul it soon.
    • From the factory on RB26s there's a fitting on the intake manifold collector/"plenum" that provides pre-throttle boost signal. That's how they did it back in the day, I figure it's fine to replicate it.
    • I would be surprised if that wasn't the issue. It's probably telling you, that even if you remove the plastic liner, you may have some other clearance issues that may occur too in some scenarios. IE, tyre to guard. It looks like someone has already rolled the lip, but you may still have issues in the future IE, turning and hitting a bump etc. The fact it changes how bad it makes the noise when you are going backward vs forward is highly indicative that it's the tyre rubbing. They do make a terrible sound, even if you're only pushing a project car that has a liner hanging down on a tyre!   Has the car been lowered? If it has been, what is the measurement from the centre of the wheel hub to the lip of the guard straight up?
    • Summernats cruiser?
    • Mark's a bit smarter than people give him credit... He'd convince the person that is to become dead, to drive him to the forest first. That way his car has no evidence in it, and he's free to dispose of their vehicle permanently how he sees fit too...
×
×
  • Create New...