Jump to content
SAU Community

Recommended Posts

Gonna put up a bike cruise thread later this arvo, thinking meet tomorrow ~11am in Albert Park and head down the Esplanade / Beach Rd, find somewhere for lunch. AP seems pretty central meeting wise an Beach Rd is bike friendly. Any input?

Starts building nice skyline.

Skyline peeps buy bikes.

Lol,

Johnoe, well played. You flamin mongrel.

Not sure if I should get plates...

To randoms. "Mohomo" would translate to mo' homo as in more homo right? If so, you should get them.

Farkin wasp stung me in the back while driving, hard enough to concentrate on the road with the setting sun right in my eyes!

Fkn tell me about that, I rode thougha swarm of bee's one day, open face helemt and they went in under the goggles down my jacket everywhere.

hard on brakes dropped the biek in the grass on side of road and did a small strip show..

not my finest moment

lucky in the country so I think no-one saw..

LMAO funny as shit in retrospect but dangerously scary at the time hey. Just like when I had a giant piece of fish and chip paper fly up from the road and cover my helmet leaving me blind @ 80km/h...

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...