Jump to content
SAU Community

Recommended Posts

these will be too big man. wayyy too big..

how is it gayer than mohsen? i enjoy the fact i dont have to be scared of being defected when I drive now.

Ric I didnt even know you had a car til after SNS.. that makes you gayer than mohsen.

these will be too big man. wayyy too big..

how is it gayer than mohsen? i enjoy the fact i dont have to be scared of being defected when I drive now.

Ric I didnt even know you had a car til after SNS.. that makes you gayer than mohsen.

You being unaware has no bearing on my sexuality brah

My car is mad

Finished exams yesterday so today I've started work on the gtr again.

Woke up nice and early in the morning, got all the nuts off the plenum

and a few hoses that hadn't been removed yet. Timing belt is off also.

Task is to remove plenum in the car, to my understanding it involves a lot

of swearing but I never thought this much..

How the fu(k do I take this mother of a plenum off? I've unbolted the air

chamber underneath and still no luck. Is it easier to pull them off the throttle

bodies or easier to pull both out together? I can't see seperate nuts/bolt heads

for the tb's so I'm assuming it's just long as studs coming off the head through

the plenum flange.

God and sau help me

Parents cheaped out on you and bought you imitation Lego. Or Duplo, which was Lego for tards.

Had lego lego, had the mates an stuff, just had an imagination and didnt need to be told what to make :P

3 months back I bought the Super star destroyer Ultimimate colletor series

over 4 foot long and over 3000 peices.

http://lego.wikia.com/wiki/10221_Super_Star_Destroyer

instructions come in handy.

not building it till I get a bigger place as no-where to put it atm

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.  
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...