Jump to content
SAU Community

Recommended Posts

yeah it doesnt worry me cos its my dads

he loves recording free to air stuff so he can put up with the ass features =)

ive got two wd tv live's in our house

bulletproof and plays every movie

ive even got two cisco switches now so its a pretty good setup

14 active ip's in my house =)

About to watch The Hobbit...

Watching at Doncaster shopping town... A note to any low brahs... Go up straight to multilevel. f**k the area outside the cinemas. Speed bump + humps are like freaking spikes in NFS, dat scraping :(

About to watch The Hobbit...

Watching at Doncaster shopping town... A note to any low brahs... Go up straight to multilevel. f**k the area outside the cinemas. Speed bump + humps are like freaking spikes in NFS, dat scraping :(

Wait till you go down the exit ramp bro. Scrapes like a mofarkin hustler.

Always get scared of the ramps in the Kings Way carpark at crown...never scraped once though. Deceiving.

Wilson's Parking on the other hand...owe me about 5 or 6 front bars.

About to watch The Hobbit...

Watching at Doncaster shopping town... A note to any low brahs... Go up straight to multilevel. f**k the area outside the cinemas. Speed bump + humps are like freaking spikes in NFS, dat scraping :(

Yeah, it's bad up there. Hadn't scraped on any of cars I now have and had.

Good thing I don't have to park all the way up all the time since xmas is over - easier to get parking closer to work.

I'm not too far from franga maybe I can pick one up for you?

Let me call them directly tomorrow and check if they have it, then I'll collect it from you at go karts. :thumbsup: That reminds me, i need to pay for that!

So.

I'm going to be having an informal(perhaps) interview at a HR company for my internship, ceo said "lets have coffee"

and i'm going in full formal, is that a right decision? tie blazer and all dat.

Intern at HR company hide all peircings and that butterfly tattoo.

but in reality your going for a job at a i'm assuming professional company, you should suit up as ther a good chance that what you will be wearing on a daily basis.

So. I'm going to be having an informal(perhaps) interview at a HR company for my internship, ceo said "lets have coffee" and i'm going in full formal, is that a right decision? tie blazer and all dat.

http://youtu.be/6Dtn4kP7lrA

So.

I'm going to be having an informal(perhaps) interview at a HR company for my internship, ceo said "lets have coffee"

and i'm going in full formal, is that a right decision? tie blazer and all dat.

Is it a city job?

Suit up bro

Like Martin said likely you'll be wearing that everyday

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So, this shouldn't be such a mission, but there were a few tricks so I thought I'd post up a DIY for it. This was on a Q50 Red Sport but I doubt any other V37 model is very different (maybe just less steps for the intake heat exchanger hoses) I pulled the radiator out to flush it because the car was running hot at the track, but obviously the same steps apply for changing a radiator for any reason including an upgrade. If you are removing the radiator, you of course need to drain and refill, so have 5+ litres of blue coolant ready. You don't need to drain the intake heat exchanger to remove the radiator but depending on your plans you may need a couple of litres for that as well. You will also need something to deal with the auto transmission lines, I used 2x 8mm rubber caps on the radiator side, and a short length of 8mm pipe on the car side.....unless you can block these lines quickly you will loose AT fluid and it may be enough to hurt the transmission if you don't refill it. Other than that....lets go... "First, jack up your car". Yes really, and put it safely on stands. If you are not confident doing that you need to give this job to a mechanic
    • If the forester is anything like our old 2007 GTB Liberty, I could near on run ling Long's and "rate them", as no matter what, it just hung to the road, even when abusing it in a hard launch in the wet, or throwing it at corners.
    • LOL, all of the CAI like Craig I just need to put a hole saw through my bumper Done and dusted, the car runs, which is nice, I'll take it for a spin when the weather clears up Just need to put the bumper back on for good
    • Brooooo Please send ABS control unit schematic Please! R33 gts25t ABS (Its two plug ecu, black and white) wire colors possible? [email protected]
    • Don't even try to run it on the stock ECU if you're going to have the boost controller bring boost above ~10 psi. I've already told you that. If you use the Nistune ECU, you will need to CAREFULLY read the available documentation for Neo tuning, and read some threads on the Nistune forums, to discover the various things you have to do to prevent the ECU from going bananas when the boost is too high. The is a table associated with th boost sensor that must be modified to prevent it from shitting the bed. This is just one of the things that you will need to do to the tune in Nistune, because the Neo turbo ECU will be expecting to see a number of things (such as the TCS) that are not there, and you have to block the DTCs on those. It is totally not surprising to me that you are having the problems that you are, but the solutions to these problems have been known for >15 years. So just get it done.
×
×
  • Create New...