Jump to content
SAU Community

Recommended Posts

Morning all! How's the weather in Vic? Today we have highs of 25 and lows of 7 in Brisbane. :)

It's sunny outside. No idea how cold/warm it is though.

It's very warm outside yet I have the man flu. This sucks. :(

How is sir grant? Has Chants contacted you about the fuel pump?

Bugger about man flu.

I'm well thanks, just busy with car shopping.

No, she haven't contacted me about fuel pump yet although I haven't checked my thread - doing it now.

Bugger about man flu.

I'm well thanks, just busy with car shopping.

No, she haven't contacted me about fuel pump yet although I haven't checked my thread - doing it now.

She may be interested. 044 will fit straight into a r34 right? No changes to fittings? Can you let us know what postage to 4053 would be? Cheers!

She may be interested. 044 will fit straight into a r34 right? No changes to fittings? Can you let us know what postage to 4053 would be? Cheers!

044 will fit with some swearing, couple of fittings some wiring, a filler sock, (there's thread in DIY about installing 044 into Skyline), postage would be $10 give or take.

I took it out and replaced it with another 044 thinking it's faulty but it turned out to be wiring that is faulty...

EDIT: http://www.skylinesaustralia.com/forums/topic/111401-bosch-044-intank-r32-gtr/

044 will fit with some swearing, couple of fittings some wiring, a filler sock, (there's thread in DIY about installing 044 into Skyline), postage would be $10 give or take.

I took it out and replaced it with another 044 thinking it's faulty but it turned out to be wiring that is faulty...

EDIT: http://www.skylinesaustralia.com/forums/topic/111401-bosch-044-intank-r32-gtr/

I thought that the 040 was the one that required a bit of finesse to get in? All good. Ill ask her to pm you and work it out. :)

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.  
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...