Jump to content
SAU Community

Recommended Posts

C63 is not rated to tow, and cannot get the MB tow bar on it with the rear bumper/difuser thing.

so you would have to change/cut parts of the back of the car to tow..

Can do it with minimal visibility, been done plenty of times

Wouldn't be too eager to start hacking a c63...

Just google imaged the BMW M4... looks pretty sick..what kind of engine and specs are we talking?

$80k brand new sounds pretty good

There's no hacking and you can remove the tow bar

M4 is a 3L inline 6 twin turbo (like the E92 335i). I think something like 320kW and 500Nm+ ? And maybe the car will weigh 1500kg tops.

And considering M4 is replacing the M3 coupe, I'd expect ballpark $ to be around what those went for.

Looks like the 135i thing I don't like is how small they are in real life. Maybe 235 be a bit bigger and nicer

Dat interior pretty sick doe. What's the retail on one of those? (inb4 more than you can afford pal, BMW)

Edited by UNR33L
Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...