Jump to content
SAU Community

Recommended Posts

f*k me birds use coodnt be mor rite!

Every time I rip a singel pega in me maloo some lefty greeny f*k has a f*kin sook at me the f*kin dum dogs.

That's y I votd for abbut cos I saw this ding on channul 9 that those dum lefty f*ks rooend straya and didnt even stop the boats.

f*kn just cos I work fifo an drive a fkn haich es ve dusnt meen im a dum lefty flamin mongrel rite!

  • Like 3

What's the engine in it?

The engine description is turbo 3L so I'm assuming a variant of the VG30. I'm not really clued up with anything other than a RB or VR38 so I'm just guessing i9t's based around a VG30 lol

Lee, what about an Aristo? Luxo barge with 2J goodness :)

Say no to the toyota 2J band wagon.

And say no to selling the pulsar, you cray.

Will try convince missurs to flog off the astra and get the gloria. Get some dish, maybe get scotty to do manual conversion... Later wind up the boost.

Its a VQ30DET btw. Apparently 350Z box is an easy-ish swap. And also apparently steer well clear of the VCT 5 speed auto boxes.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...