Jump to content
SAU Community

Sau Vic Show And Shine Oct 21St 2012!


Recommended Posts

  • Replies 119
  • Created
  • Last Reply

Top Posters In This Topic

For low cars I'm sure we can organise wooden planks for any super low cars.

Also need to re-iterate:

  • Entry to the show is free to the public if you want to come have a look
  • Only SAU VIC members can have their car on display (per council permit)
  • The $50 is a membership drive for new SAU VIC members. Normally it is $70
  • Membership will pay for itself and then some if you ever decide to use our sponsors/supporters. Also need to be part of a CAMS affiliated club if you do ever decide to track your car.

Perhaps the same people who were worrying about static move in/out times at docklands last year! No more mention of the war / the entrance...we will have it covered! Worst case scenario, you don't like the look of it and drive home :)

So for a topic change, how does everyone prepare their car for this sort of thing? Do you polish and wax, full monty or just a quick squirt off at the pay n spray?

Should be great walking traffic at Como, I've heard the place populates on a sunny day.

My preparation will consist of the following.

- Get out of bed

- Shower/clothe myself then eat breakfast.

- Get into lift, go to my car, open doors start it

- Drive to Como park

- Park car

- Admire it in it's full commodore glory

- Go home

Just a quick wash and go for me

Unless someone really feels like washing, clay bar, polish, sealant & waxing my car for me :D

na leave all the rubber marks from the track day on there ;)

My preparation will consist of the following.

- Shower/clothe myself then eat breakfast.

Geee aren't we lucky ones!!

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • If it (the code) wasn't still current, it should have gone away by itself by now. No, nothing it 10/10. But it is quite likely. Everything else to do with the ignition could still be responsible (which is wires and connectors). The car is an old piece of shit now, so all the wires and connectors are also old pieces of shit.
    • Lock me in mate, although I'm not sure if I'll be heading up from Goulburn or down from Sydney, either way, return will be back to Goulburn 
    • Sounds good, we will aim to be there! @The Bogan I'll give you a shout if you are heading up to campbelltown for the meet too.
    • Before I get to the test day, just to finish off the android head unit. This is a demo from car start up....the standard/host system takes a few seconds to boot (same as all v37) but Android comes up quickly. In this vid I'm using the delivered launcher but have set the default to Agami since which is easier to navigate when if use primarily 5 apps. You can see the host system still takes over when required eg putting it in reverse, and you can switch between Android and not by holding the back button 3 sec. It is pretty responsive (fast) but you can see I had to press harder than expected a couple of times.  I still have the phone connected to the stock system, and that also seamlessly takes over Android music playing. v37-android-demo.mp4 The bigger reason that I put this in though is so that I can use Ecutek directly on the head unit. That gives me a dash with logging (up to 20MB only), high and low value warnings on any parameter etc etc. I've run a USB cable from the Ecutek OBD dongle to a USB input on the unit, easy. v37-ecutek-demo.mp4   The unit did freeze on the launcher the other day, I think Agami was trying to verify the license when it didn't have a data connection...will monitor and report back if there are any other problems but so far I'm very happy with the upgrade.
    • Nah that is just crappy GPS mapping, I did have a small excursion (cold tyres, damp track, surprise!), will post up that when I get a chance.
×
×
  • Create New...