Jump to content
SAU Community

August Monthly Meet - Wednesday 14Th August - Kebab Joint


Recommended Posts

You ass.

Scott is as lazy as I am.

But we have a comittee meeting coming up ill bring it up and see what happens.

schweet. they do it in narre warren/fountain gate etc.

  • Replies 148
  • Created
  • Last Reply

Top Posters In This Topic

not gonna risk my ankle on a sport i suck at.

lets have an sau cycling team.

We're a car club, you're suggesting that we switch to a mode of transport which removes engines from the picture... plus do you have any idea how much performance enhancing drugs cost? Pettit is all over that shit.

Not liking the chances of a SAU VIC soccer team lol

But it doesn't hurt to ask

hahah its only five a side. im the tits so just need four other guys who can pass it too me. hahahah!

We're a car club, you're suggesting that we switch to a mode of transport which removes engines from the picture... plus do you have any idea how much performance enhancing drugs cost? Pettit is all over that shit.

scott can always devise a method to attach engines to bicycles. owait.

What about SAU VIC Tough Mudder????

have done the uk equivalent a couple of times. its shit. for 200 dollars pp its a complete rip off. your paying that much to do a shite army assault course.

but each to there own.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...