Jump to content
SAU Community

Recommended Posts

You need data from the car. Imagine Pastor gives you a tap in the first corner. 6 laps later you are going into a 6th gear 280km/h sweeper and your rear wing fails. Someone can be hurt of killed, spectators , marshalls....when if the pit could see that they had strange downforce readings they will pick up that the rear wing may be damaged. Ditto ERS systems. Can see for verious safety reasons they need to be able to monitor the health of the cars

Easy. Publish a list of what is ok to transmit for safety reasons. Rest can be logged only. Can be a on/off go/no go signal so if for example the aero load goes below a certain value then the fault signal gets sent and the driver pits. Still better than Fernando is faster than you style nonsense.

There won't be a problem if the it is monitored by the stewards, even post race. Judge whatever the teams say and penalise calls that break the rules.

As above - Rear tyre/aero failing, a radio message telling the driver that there may be a problem with the rear tyre/aero - acceptable

Radio the driver telling them - setting 3 for diff, should see a 0.1sec gain in sector 2 - not acceptable

I think, as mentioned, some 'reactive' radio transmission need to occur for safety reasons. I don't think you can simply program the car to send a good/bad status signal. The cars probably have at least 2 sensors for just about everything, imagine what happens when a sensor fails? And believe me it does happen. The car would immediatly send a bad signal. Teams need to be able to watch parameters to avoid grey areas like this.

I know there will be 100 different coded messages to get around the rules for radio transmissions in these situations, but to me its something the teams have to have. Theres alot of reasons for and against, but this is how I see it anyway

There won't be a problem if the it is monitored by the stewards, even post race. Judge whatever the teams say and penalise calls that break the rules.

As above - Rear tyre/aero failing, a radio message telling the driver that there may be a problem with the rear tyre/aero - acceptable

Radio the driver telling them - setting 3 for diff, should see a 0.1sec gain in sector 2 - not acceptable

I think, as mentioned, some 'reactive' radio transmission need to occur for safety reasons. I don't think you can simply program the car to send a good/bad status signal. The cars probably have at least 2 sensors for just about everything, imagine what happens when a sensor fails? And believe me it does happen. The car would immediatly send a bad signal. Teams need to be able to watch parameters to avoid grey areas like this.

I know there will be 100 different coded messages to get around the rules for radio transmissions in these situations, but to me its something the teams have to have. Theres alot of reasons for and against, but this is how I see it anyway

Be sad to miss out on the lulz when the drivers cant remember what the codes mean.

"Kimi, the rain in Spain falls mainly on the plain."

"WTF does that mean".

But more seriously subjectivity in rule interpretation is usually where you get the biggest shit fights. eg its ok for Ferrari to install their barge boards on the piss but its not ok for anyone to drive around a hundred metres in front of them in quali lest they upset their aero.

Also if they can trust a fuel flow meter to be within 1% accurate they can trust a temperature or pressure or strain gauge,surely? None of that prevents the info coming up on the steering wheel. Some of the teams are already having a whinge their displays are too small.

Be sad to miss out on the lulz when the drivers cant remember what the codes mean.

"Kimi, the rain in Spain falls mainly on the plain."

"WTF does that mean".

But more seriously subjectivity in rule interpretation is usually where you get the biggest shit fights. eg its ok for Ferrari to install their barge boards on the piss but its not ok for anyone to drive around a hundred metres in front of them in quali lest they upset their aero.

Also if they can trust a fuel flow meter to be within 1% accurate they can trust a temperature or pressure or strain gauge,surely? None of that prevents the info coming up on the steering wheel. Some of the teams are already having a whinge their displays are too small.

His response would more likely be

"yeah yeah yeah I know where the rain falls in Spain you don't have to tell me all the time "

  • Like 1

Hmm Kimi must be spewing. He finally finds some speed and the car fails him.

Lots of anger about. Grosjean with the dummy spit, Britney the same. Good job by Dan, Massa and Homo too.

Should be a cracker of a race. Wonder how long the super softs will last.

Disappointing Q3 from. Ferrari.. They seemed to be right on the pace all weekend.. Pretty close to the mercs times but dissapointing to be so far down the grid... Hopefully they can both get off to a good start and make it an interesting race

Some of them kick in at Singapore, others like tyre and brakes take effect from Japan.

Pretty dumb if you ask me. Implement strict 100kg fuel limts. Ban teams and drivers from talking about fuel during race.

You can't tell your driver when to back off to save fuel, but you can tell him when to push and not save fuel. huh?

No talk about ERS states and adjustments might mean people will retire due to problems with the system. Same goes for brake temp/wear but it's pretty easy to configure dash warning for that one and any driver seeing a rear brake temp/wear issue would know how to handle that. Not neccesarily so easy with ERS.

The way I read it, you can tell a driver to save fuel, you just can't tell them how much. But there is also a simple fix to this. Fuel the car with enough fuel to race hard for the whole race, instead of for 90% of the race and hope for a safety car.

As for telling them how fast others are, they can still do it, just not as far as sectors go. They can give lap times.

Personally I think the changes are a good thing. Less micro managing, more just driving

Magnussen deserved a penalty - the other car was fully alongside - you can't just run them off the road in that situation. The only harsh part is that one certain other driver has been getting away with the exact same thing all season for some reason...

Stewards are a joke. AJ, I'm looking at you... Last race Magnussen gets pinged for running someone off the track ont he exit of a corner. Lst night a Lotus did the same thing to JEV and JEV got pinged for exceeded track limits. Get your shit together FIA. Any normal category has a single driving standards position for consistent decisions. Time the world's premier series did the same ffs.

Yeah some favourite RBR tracks coming up where they'll be as close to Mercedes as they're ever going to be. Singapore, Suzuka...

scrap that. They might be RBR favourite tracks, but they were no closer to the Mercs when they stopped fooling around. RBR can forget Suzuka too. They'll be fighting to be best of the rest.

Edited by hrd-hr30

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Can I suggest you try EBC directly again and link them to as many competitor catalogues as you can to show their listing is incorrect, eg https://dba.com.au/product/front-4000-series-hd-brake-rotor-dba42304/ If you have access to an R33 GTST VIN and your VIN, you could also use a Nissan Parts lookup like Amayama to show them the part number is different between 33 GTST and 34 GTT which may get their attention
    • So i got reply from EBC and they just this site where you can clearly see those 296mm fronts on R34 GTT. I send them photos and "quotes" that 296mm are not for 34 GTT and they are too small. But it will be very hard to return them cuz nobody here knows 100% and they just copy those EBC catalogue :-D https://ebcbrakesdirect.com/automotive/nissan/skyline-r34
    • Hi, is the HKS  Tower Bar still available ? negotiable ? 🤔
    • From there, it is really just test and assemble. Plug the adapter cables from the unit into the back of the screen, then the other side to the car harness. Don't forget all the other plugs too! Run the cables behind the unit and screw it back into place (4 screws) and you should now have 3 cables to run from the top screen to the android unit. I ran them along the DS of the other AV units in the gap between their backets and the console, and used some corrugated tubing on the sharp edges of the bracket so the wires were safe. Plug the centre console and lower screen in temporarily and turn the car to ACC, the AV should fire up as normal. Hold the back button for 3 sec and Android should appear on the top screen. You need to set the input to Aux for audio (more on that later). I put the unit under the AC duct in the centre console, with the wifi antenna on top of the AC duct near the shifter, the bluetooth antenna on the AC duct under the centre console The GPS unit on top of the DS to AC duct; they all seem to work OK there are are out of the way. Neat cable routing is a pain. For the drive recorder I mounted it near the rear view mirror and run the cable in the headlining, across the a pillar and then down the inside of the a pillar seal to the DS lower dash. From there it goes across and to one USB input for the unit. The second USB input is attached to the ECUtec OBD dongle and the 3rd goes to the USB bulkhead connected I added in the centre console. This is how the centre console looks "tidied" up Note I didn't install the provided speaker, didn't use the 2.5mm IPod in line or the piggyback loom for the Ipod or change any DIP switches; they seem to only be required if you need to use the Ipod input rather than the AUX input. That's it, install done, I'll follow up with a separate post on how the unit works, but in summary it retains all factory functions and inputs (so I still use my phone to the car for calls), reverse still works like factory etc.
    • Place the new daughterboard in the case and mount it using the 3 small black rivets provided, and reconnect the 3 factory ribbon cables to the new board Then, use the 3 piggyback cables from the daughterboard into the factory board on top (there are stand offs in the case to keep them apart. and remember to reconnect the antenna and rear cover fan wires. 1 screw to hold the motherboard in place. Before closing the case, make a hole in the sticker covering a hole in the case and run the cable for the android unit into the plug there. The video forgot this step, so did I, so will you probably. Then redo the 4 screws on back, 2 each top and bottom, 3 each side and put the 2 brackets back on.....all ready to go and not that tricky really.      
×
×
  • Create New...