Jump to content
SAU Community

Recommended Posts

A few shitty cars like Mazda 3s, Honda Civics.. mainly just stupid P platers

Been tailgated, slammed brakes really hard.. no more tailgating :)

Then they overtake me and abuse me, so I follow their car with a creepy smile on around till they start speeding and driving erratically.

I've followed some dumb betch home before and abused the shit out of her till she started crying. Then I said I hope you've learnt your lesson and apologised for making her cry and left.

I'm a dickhead.

  • Like 4

One serious case was i accidentally drove into a dead end construction site road at night time in Bankstown and this riced up P plate Honda Accord with big guys in it blocking off the only exit so i slowly and carefully squeeze past them and they said "Who you looking for ?" to which i said no one and sped out of that dead end then they chased me around Bankstown very closely (can't see their headlights), i had to block their lane so they cannot get in front of me as they try to overtake me to do god knows what, they even sped past a red light to chase me, i lost them by going around and around at the round about then parked in front of the Bankstown Police Station.

Bankstown is dangerous at night time and Skylines have too much negative attention.

happens all too much, usually by middle age people (say 40-50) in 4x4's that have never been off the road.

bloody tough waste of space morons!

I hit the brakes a few times to flash my lights at them, if they don't back off I then slow down and try to box them in traffic just to really piss them off. =)

  • Like 1

Single road situation, I am usually a tad over speed and if they persist I just slow down until they get the message and move back, works most of the time but sometimes it just makes things worse if you have a nutter up your butt :rant: then it is time to GO or pull over :blush:

I have a thing about young sheilas doing it and as soon as you go to a bendy part of the road the fall way back only to sit up your butt again on the straights :stupid:

A lot of the time people who get tailgated deserve it. The driving culture in Perth (where I am) especially is ridiculous. People sit in the right lane on the freeway either just doing the speed limit or a bit below and then have a little sook when someone comes too close behind them and high beam them. Here's an idea, bugger off out of the right lane sparky and you won't get tail gated.

But offcourse you do have those idiots who will tailgate you irrespectively so yeah....

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I'm normally copping my own abuse from neglecting my daily drivers. "Those suspension bushes will last a bit more", "Don't worry about the oil leak, just keep topping it up". The project cars I'm always doing things slowly on them as I'm wanting them to be done better, and neater, and nicer. Luckily I don't have to deal with 18 year old Matt's "Learning to wire" stuff in the project cars. And there's only one piece of wiring I'm displeased about in the Landcruiser, and it's about to be cut out... However, the box loads of parts that have been going through this place lately for the Landcruiser... Brake pads Brake Rotors Full handbrake overhaul Wheel Bearings Seals Swivel hubs Steering Boxes Half the suspension joints Shocks Air bags (Ones to go in the rear springs for towing) Water pump Timing kit Lower timing case Harmonic Balancer Radiator Lots of other little seals and shits Gas struts for the bonnet New power window switches And god knows what else I've forgotten... Ha ha ha I have my fingers crossed the pinion seals don't start leaking on the diffs, that the transfer case doesn't leak, and the gearbox input shaft doesn't leak, nor the rear main seal. As they're about the only seals I haven't replaced in the driveline! I'm seriously eyeing off buying new caliper rebuild kits front and rear brake calipers... I'll probably recheck all the valve clearances soon too, and hopefully, it should be all good and sweet to haul some long distance trips again!
    • Every time I pull my 3x gauges out of the console and see the crack-addict way that I did the wiring, and I just can't bring myself to tear it all apart and "make it nice", because it is currently working. In fact, the last time I was in there I probably made it worse.
    • The best part is when you own the car long enough that you look back and find your OWN ham fisted amateur shit!
    • The annoying part about neglect, is when you start to replace one thing, and find ten more broken things. Ham fisted monkey repairs you normally only find out about when trying to do something unrelated! Ha ha   Neglect you can kind of anticipate the huge costs to fix it all. Ham fistedness is normally a shock the first time your work on a new old car, as everything "looked" good before.
    • For DBA, check out their guide table here. https://dba.com.au/wp-content/uploads/2023/01/Direct_Replacement-Guide-2021.2.pdf   Additionally they have some other guides and info on how to make sure you choose the right pad.
×
×
  • Create New...