Jump to content
SAU Community

Recommended Posts

To confirm the changes,

I am quite concerned actually, as all I have been doing over the last two texi events were skids and linking corners. How strict will these rules apply to suppress ‘induced power sliding’?

Sliding the rear end of the car around the cones, is acceptable. If it turns into drifting or burnouts then it become not acceptable.

As Duncan said, the rules are just a clarification of a motorkhana event. Insurance has asked us to reinforce those rules.

The first post will be modified with the changes.

Yeah it's not that easy to follow all the cones and course at speed

Sometimes it gets abit out of control and you end up spinning and frustrated and smoke it up alil

If that's not on might have to cancel

How strict are you's on it

3 warnings and no more or just get told to take it easy

Smoking the tyres to get to the next gate quickly is fine. Smoke until you can't see your car, not ok.

We can only run these events while we are insured by AASA. We don't make these rules, they do.

If you are clearly breaking the rules we will give you a couple of warnings. If the clerk of course feels that you've been warned and continue they we can ask you to leave. It is all about us keeping our insurance rating so we can continue to hold these events.

Fingers crossed, the motorsport gods have been angry and thus I have not had any car fun lately, if all goes well and the stars align I shall be there with bells on.

And its OK for the skids from this end as the MX5 cannot do epic helis.

  • Like 1

^^^What Eric says.

MX-5's do a fantastic job at this event; good car control and a level head is the way to win.

A texi is a technical car challenge, using your memory, an intimate understanding of your car's strengths and weaknesses. Any idiot can chuck a mad skid (see any episode of ACA for further details), only a talented DRIVER can master the texi.

No one is saying that you have to drive like Miss Daisy, but if we don't respect the rules of the event, all we'll have is stationary carpark events.

How hard will people whinge if that happens?

If you are just renewing cams they get them out quickly. I did mine last week and got the new sticker this week. But don't wait too long, no current sticker to verify then we can't let your enter. Sux but that's dam insurance rules again.

  • Like 1

Work has been cancelled for Sunday, so I'm entered. I need to renew my membership , I think it's overdue by a couple of months , is it okay to do this on the Day?

Yes, you can renew/join on the day, please bring cash as we don't have eftpos

Looking forward to Sunday.

Do we have any sup regs yet? Will the course just be decided and changed on the day?

Want to make sure my car isnt missing anything that you guys deem important as its my first event with the SAU

Bum. With such an attractive car in the first post to really show the style and finesse of the event it's hard to say no, but alas i'm working the nightshift before and after the event =-/

Might be the first one in 2-3 years that I miss?




  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...