Jump to content
SAU Community

Recommended Posts

Hey guys,

The economy on my 2007 V36 SP Coupe is pretty terrible. I get between 13.3L / 100kms (mostly hwy, some city) to 17.4L / 100kms (inner city driving). I think the best ever (100% hwy) was around 12L / 100kms. I'm a mature driver too, I don't really fang it around.

Always run 98RON, 90% of the time BP, sometimes Shell. Other than economy car goes well.

Has anyone had any experience in doing some fuel tuning to increase economy? (i.e. like one would with a Power FC or Super AFC back my in my turbo days).

Anything else I could investigate?

David.

Been thread reading and seems a popular option is the Uprev, either ordered from eBay and DIY or through RevZone in Ringwood.

Can anyone comment on what one can reasonably expect from a stock V36 (with K&N drop in filters)?

Mainly I'm after fuel economy gains (and the switchable map mode sounds great - but I don't have Cruise buttons, could it would with other buttons?)

My best fuel consumption so far was 570km to the tank (about 70L) with mixed driving, city and freeway, so that's around 12.2L/100km.

I have short ram intakes, hi-flow cats, cat-back exhaust, grounding kit, new spark plugs, splitfire coilpacks and UpRev tuned.

Would be better to get any problems fixed before you think about a tune. Those figures seem quite high.. I am not sure what is normal for the V36, but they are far higher than what I get in my V35.

Does anyone know the best way to go about sorting this out?

I do service the car at a very reputable mechanic (TruTrack North Melbourne) and it's recently had brand new spark plugs and air filters cleaned. Tyres are near new too and I regularly check the pressure.

When I was working in the city, my usage was about 13-14l/ 100kms...peak hour traffic + city...you wont get good economy out of these engines considering they are pretty high revving. But your consumption does seem to be on the higher side of things. Not too sure how bad the traffic and city driving is like in Melbourne though. 100% hwy (assuming 100-110km/hr and going into the country) should get low 11s or even high 10s.

OK. So I just called around two performance workshops here in Melbourne.

They both mentioned the O2 sensor is the most likely culprit, especially in a 2007 car. The ECU doesn't get accurate readings so it overcompensates by dumping fuel. Hooking it up to a scan tool would easily ID if this is the problem ($80). Strangely, one of them recommended a Dyno to check A:F ratios and the other said it would be a waste of effort (as they want to check the car at 'cruise', not at full throttle).

Could this also explain some weird idling / low speed 'lurching' I've been experiencing? What are the common symptoms of a dodgy O2 sensor?

Edited by Haxorz

I had a failed AFR sensor (wide band O2 sensor) on my V35, but it only caused a CEL and poor economy, no other symptoms.

I would assume the HR engines also use AFR sensors?

@ sonicii - Yes, wide band sensors I believe.

OK, so I just got off the phone with Scotty from this forum (Scotts Customs). He was extremely helpful, knowledgeable and good to talk with - highly recommended for anyone needing any work done.

He reckons it's most likely a oil/dirt build up in my AFM. He says a dirty AFM will give poor economy and rough idling and it's also the only part of the car I've modified (drop in K&N oil based panel filters). He reckons it's a common issue with oil based filters (the wires end up getting covered in a combination of oil and dirty) and recommends I switch to cottom based filters. It could still be an O2 sensor (which a scan should pick up on) or manifold leak as well, but this is the cheapest thing to check/fix first.

Anyway, I'm off to buy myself a can of CRC AFM cleaner and give him a visit :)

  • Like 1

Ditto on the oil filters see if you have any dirt build up etc.

My 2012 V36 gets average 10-11L/100km 60/40 (City/Hwy) and drops down to approx 9/100km on long haul country (110km/hr) trips... But that's just the 7 speed working its magic. Good luck!

Alright... an update.

Visited Scotty last night, cleaned out the MAF sensors and checked for error codes with Consult. The sensors didn't look particuilary dirty but given their tinyness and sensitivity it's still worth doing. Turns out it's an extremely easy job on the V36 once you know how (and should be done after air filter re-oil, or better yet, avoid oil based filters).

Consult showed the O2 sensors working well. There were a whole bunch of logged error codes back 32 starts ago when my battery and alternator died and was replaced. These were all cleared to start afresh.

I won't really know if it's help until another 2 weeks or so of driving but I can tell already the car is much smoother on the HWY, like back when I first got it 4 years ago. I thought it might be a placebo effect but my GF noticed the same. I'll monitor fuel consumption and post the results.

For anyone looking for mechanical work in the Melb SE suburbs, I'd like to say Scotty is a great guy, very knowledgeable on the V series and highly recommended!

  • 3 months later...
Some good news. I did a big trip up to country Victoria and managed to get just under 700kms to a tank. Calculated fuel economy was 10.1L per 100kms, which is the best it's ever been by a good 100kms at least.


My 'bucking' issue on transmission downshift is still present though.


If you have used oil based filters and have economy issues I HIGHLY recommend you use some MAF cleaner.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I got back to Japan in January and was keen to get back on track as quickly as possible. Europe is god-awful for track accessibility (by comparison), so I picked up a first-gen GT86 in December just to have something I could jump into right away. The Skyline came over in a container this time and landed in early January. It was a bit battered after Europe, though—I refused to do anything beyond essential upkeep while it was over there. The clutch master cylinder gave out, and so did the power steering. I didn’t even bother changing the oil; it was the same stuff that went in just before I left Japan the first time. Naughty. Power steering parts would’ve cost double with shipping and taxes, so knowing I’d be heading back to Japan, I just postponed it and powered through the arm workout. It took a solid three months to get the car back on the road. Registration was a nightmare this time around. There were a bunch of BS fees to navigate, and sourcing parts was a headache. I needed stock seats for shaken, mistakenly blew 34k JPY on some ENR34 seats—which, of course, didn’t fit—then ended up having the car’s technical sheet amended to register it as a two-seater with the Brides. Then there’s the GT86. Amazing car. Does everything I want it to do. Parts are cheap, easy to find, and I don’t care what anyone says—it’s super rewarding to drive. I’ve done a few basic mods: diff ratio, coilovers, discs, pads, seat, etc. It already had a new exhaust manifold and the 180kph limiter removed, so I assume it’s running some kind of map. I’ve just been thrashing it at the track non-stop—mostly Fuji Speedway now, since I need something with higher speed after all that autobahn time. The wheels on the R34 always pissed me off—too big, and it was a nightmare getting tires to fit properly under the arches. So I threw in the towel and bought something that fits better. Looks way cleaner too (at least to me)—less hotboy, less attention-seeking. Still an R34, though. Now for future plans. There are a few things still outstanding with the car. First up, the rear subframe needs an overhaul—that’s priority one. Next, I need to figure out an engine rebuild plan. No timeline yet, but I want to keep it economical—not cutting corners, just not throwing tens of thousands at a mechanic I can barely communicate with. And finally, paint. Plus a bit of tidying up here and there.  
    • Nope, needed to clearance under the bar a little with a heat gun, a 1/2" extension as the "clearancer", and big hammer, I was aware of this from the onset, they fit a 2.0 with this intake no problems, but, the 2.5 is around 15mm taller than a 2.0, so "clearancing" was required  It "just" touched when test fitting, now, I have about 10mm of clearance  You cannot see where it was done, and so far, there's no contact when giving it the beans Happy days
    • It's been a while since I've updated this thread. The last year (and some) has been very hectic. In the second-half of 2024 I took the R34 on a trip through Germany, Italy, France and Switzerland - it was f*cking great. I got a little annoyed with the attention the car was getting around Europe and really didn't drive it that much. I could barely work on the car since I was living in an inner-city apartment (with underground parking). During the trip, the car lost power steering in France - split hose - and I ended up driving around 4,000kms with no power steering.  There were a few Nurburgring trips here and there, but in total the R34 amassed just shy of 7,000kms on European roads. Long story short, I broke up with the reason I was transferred to Europe for and requested to be moved back to Japan. The E90, loved it. It was a sunk cost of around EUR 10,000 and I sold it to a friend for EUR 1,500 just to get rid of it quickly. Trust me, moving countries f*cking sucks and I could not be bothered to be as methodical as I was the first time around.
    • I assume clearances were all a-okay?
×
×
  • Create New...