Jump to content
SAU Community

Recommended Posts

I offerd them $50 for their budget if they let me crash. I am trying to tell them it would be such a mega, properly epic crash that whatever sponsors they have will love the coverage it will get. it will be iconic.

Renault Would love you!

Pretty sure they always show practice when it's the aus gp..

Getting foxtel installed next week so I won't have to worry, every session live in sweet HD and no Alan Jones or rusty to put up with, no ads and heaps of F1 related shows as well

Its only the Aus GP people. Its the same every year. The races that 10 do show will be with the sky team commentating

Apparently the foxtel broadcast is great. Adding the pack next week prob.

Been some pretty average commentating on ONE of the little bit of coverage ive managed to see. Thet were getting confused that someones time hadnt been registered, finally realised it was because it was an out lap. Saying Nasr's name wrong. Webber is def saving it

Will be interesting to see how the qualifying speed of the cars compares to race speed tomorrow. Last year the rbr cars were quicker in race trim than their qualifying speed showed. Mclaren out the arse though, unless they've still not turned the car up to 100% yet, but I doubt that's the case.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Thanks GTSboy. I will inspect the valves actually, is this something I can do while they are still in the head? The block/bores don’t look bad to be honest hey, I can still see the cross hatches in the bores and they still measure 86.5mm. I’m not sure how to measure the installed ring gaps but I will do that and take it to someone who can. 
    • I’ve had the same headache with my lowered car, scissor jack first then floor jack every time. Ended up grabbing an extra-low profile aluminum jack (about 70mm entry height) and it finally slides under the lip without drama.
    • No sync errors , i have installed AEM disk will return original 360 slot disk and check if there’s any one with running AEM disk could share setup 
    • Its been a while! Finally thought to do something on this car, so here we go. This will be a slow burning, multiple posts as I spend 0.5-1hr a day on this job, over multiple days... Full set of GKTech suspension arms!   Step 1: Buy Arms, done! Step 2: Start removing stuff. HICAS was easy. Rear suspension arms are now gone, they were a bitch but breaker bars with long handle extensions, 2 1.5hr slots later, stock arms are off! Next step, remove the hubs and take them to work to press out the bearings and bushings!  
×
×
  • Create New...