Jump to content
SAU Community

Recommended Posts

Don't be too picky on the exact car you want, even though I may sound like a hypocrite as I was exactly like this.
I would take a R33 over R34 any day simply as it's more of a Pure, streamlined car.

The V-Specs or M-Specs might be harder to find, but the smarter choice when buying GTR's is not to go off by impulse, but to go off by what condition the car is.
If you've ever owned one you will know that they can be costly at times to upkeep in the long term, and a car where the owner has not done that or done tacky mods
generally is a rough car where poor paint jobs, bad servicing will show up later.

  • Like 1

Morning all.

Today, I have work at 12, so I plan on ringing KYP just before I leave to find out if Uneeda actually picked up the door, and if they haven't i'll ring them again tomorrow, and if they still haven't, I'll have to drive over there and find out why.

  • Like 1
On 7/16/2016 at 8:51 PM, RB335 said:

Hi Everybody.

Our next event is locked in, a breakfast meet and greet.  More information on the events page and link below :

http://www.sau.com.au/forums/topic/465831-breakfast-meet-23rd-july-saturday/

I should be able to make it, hope it's not raining!




  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.  
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...