Jump to content
SAU Community

Recommended Posts

Hi all, I was a member about 6 years ago and now I got myself a fresh import gtst so I'm back in the game.

Just received my 32 off the boat and was so excited to have another 32 in my life but... my joy was short lived.

After a initial drive, i noticed the car was losing power at random points and when i put the foot down it suddenly goes again and loses power again.

This was the first problem. second is when I had to stop behind another vehicle, at low rpm even with my foot down on the clutch, the car shut down completely so I had to quickly restart it.

I initially drove home and after the first 10 mins of problems, it behaved OK even in the evening when I took it out again and gave it a good run (That's what I thought it needed after being stationary fir a while)

This morning, I gave my new baby a wash and a wax and started the car to warm it up and went inside the house, 5 mins later I went out again because it was too quiet, but to my surprise and horror, the car shut down by itself....

I attempted to start it and it did, for about 5 seconds and RPM dropped and died. this repeated about 3 times before I left it alone for about 10 mins before attempting it again.

10 mins later it started after I put my foot down and it somehow managed to stay alive. I went for a drive and just around the corner when I stopped at an intersection, it died again.

My first skyline had a similar issue, from memory it was the Air Flow Meter.

I was reading the posts and found some similar cases but wanted your inputs in diagnosing what it could be.

The car is a 1993 R32 GTST done 67km Japanese auction grade 4.

its got a ARC super induction box, aftermarket intercooler, and a non vent to air bov.

My first guess is either the AFM or the TPS or coilpack. since it sometimes takes a bit of crank to start her up.

Please let me know what you think.

Link to comment
https://www.sau.com.au/forums/topic/459260-r32-gts-t-problem-losing-power/
Share on other sites

... started the car to warm it up and went inside the house ...

Please don't do that. It wastes fuel and causes damage to the engine (most engine wear occurs during warm up). Also makes the car vulnerable to theft, as one Porsche owner in Canberra can attest!

Back to your problem - get the injectors cleaned, new spark plugs, change oil / filter.

So could be spark plugs, afm,

What is AAC? Timing= belt?

Fuel pump and pressure seems to be ok, but fuel filter I'm not sure about...

And boost leak? The car was running fine after the initial fit it had so I assumed was all good but I was wrong... Seems to boost well when it's working so maybe no leak,,

And finally.. Never knew warming up the car can do damage..... Is this really the case? I thought it was the opposite

One more question for you then, the car sometimes starts up well, but sometimes needs a good crank + tap on the pedal to start up. Is this just old spark plugs or coilpack or a battery that may need replacing soon?

ok, when i talked to the workshop, the car has a standard ecu and has never been tuned in the past from what they can see.

so that's probably out... but by other things, it means something ignition related no?

like spark plugs or coil pack etc?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
    • I've managed to find this: Nissan_Stagea_AutechVersion260RS (1).pdf
×
×
  • Create New...