Jump to content
SAU Community

Recommended Posts

1 hour ago, Mick_o said:

Lol .63 on a 3L?! You have alot to learn young Jedi... Measure your turbine pressures or flog your car for a while and see how long the head stays on it with a .63? 

Depends what your doing with it, mines not corked at all, keeps making power past 7500rpm, its a street car and wont see a track to be flogged non stop, if its only street car then id rather it have more low end as id rarely hit 7500rpm on a local street.

43 minutes ago, AngryRB said:

Depends what your doing with it, mines not corked at all, keeps making power past 7500rpm, its a street car and wont see a track to be flogged non stop, if its only street car then id rather it have more low end as id rarely hit 7500rpm on a local street.

I guarantee you wont make more low end with a smaller turbine.

Trying to bring boost on early doesn't make more power earlier. 

If your engines exhaust gases cant get out due to a small turbine restricting flow its gunna lose power down low and produce less torque off boost when putting around on the streets off boost. 

 

  • Like 1
2 hours ago, AngryRB said:

Gt3076 0.82 on my 30, plenty big enough, could even go down to 0.63 as still takes some revs to wake up.

Road use, the 3076 0.8A/R combination is damn hard to beat.  They pull down around 2000, and run up to 7000 without falling over.  They're not magical, but it's tried and proven.

If it's track, go to a 3576 0.8A/R.  Provided you're wearing blinkers and only want Garrett.  As per Piggy's comment, you need to let it breathe out.

  • Like 2
3 hours ago, Griffin said:

I'd imagine a .82 on 3576 would work much better.

Would be a good set up but if you're looking to make over the 400kW Mark I would seriously jam a bigger rear on.

Once I outgrow my turbo I may look along those lines however a GTX3576 with a 1.0x ish rear and twin scroll everything - blah blah blah lol 

2 hours ago, Dose Pipe Sutututu said:

Would be a good set up but if you're looking to make over the 400kW Mark I would seriously jam a bigger rear on.

Once I outgrow my turbo I may look along those lines however a GTX3576 with a 1.0x ish rear and twin scroll everything - blah blah blah lol 

I'm not looking for 400+ out of this as it's just a stock low km bottom end. It's in a cefiro . About 350 would do

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • There's restrictor pills in the stock boost control hoses. That's how they set the amount that was bled off and hence the "high" boost setting. The usual mod in the day was to remove it and send the "high" boost setting up to about 14 psi.
    • Thanks Duncan, that's the best info I've read. Furthermore after learning about the PCM programming side controlling the factory boost solenoid, the purpose of the solenoid is to "bleed" boost when pin 25 is earthed, thus allowing spring pressure in the wastegate actuator to overcome diaphragm boost pressure, thus closing or reducing the position of the wastegate flap creating more boost as the turbo is able to spin faster. It's pretty cool to see a designated Pill to do exactly this, would have liked to have seen it with a tiny filter over the end for those moments in vacuum.  The constant bleed pill has now been removed completely from the system and solenoid boost control has been restored once again.   Case closed 😂
    • The wideband reading is meaningless if it's not running. Why are you using shitty old sidefeeds on any engine, let alone a Neo? What manifold and fuel rail are you using to achieve that? Beyond that, can't help you with AEM stuff as I've never been their ECU/CAS combo.
    • Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
×
×
  • Create New...