Jump to content
SAU Community

Recommended Posts

Hi Guy's,

Looks like the country is going into lock down (corona virus) so planning to do a major oil change on my stock R32 GT-R. Looking at using

Motul ATF-1A for power steering, any good??

Motul 8100 X-Power for Engine Oil

Motul Dot 3&4 for brake and clutch fluid

Red line Heavy Shockproof for Gearbox

Diff oils??? need help

any advice would be appreciated on the list above
 

Thx Bob

 

Link to comment
https://www.sau.com.au/forums/topic/480010-r32-gt-r-oils/
Share on other sites

1 hour ago, borka1975 said:

Motul ATF-1A for power steering, any good??

Anything will do.

1 hour ago, borka1975 said:

Motul 8100 X-Power for Engine Oil

It's fine, along wih about 300 other options.

 

1 hour ago, borka1975 said:

Motul Dot 3&4 for brake and clutch fluid

Anything will do here too.

 

1 hour ago, borka1975 said:

Red line Heavy Shockproof for Gearbox

Only if the gearbox needs help shifting. Do not use it in a healthy box.

1 hour ago, borka1975 said:

Diff oils???

Anything will do here too. Just so long as it is for LSDs.

  • Haha 1
Link to comment
https://www.sau.com.au/forums/topic/480010-r32-gt-r-oils/#findComment-7927004
Share on other sites

As GTSboy said really apart from diffs. I really disagree with the light oils on diffs like the 75w -85 or 75w-90 stuff Nissan recommends, and absolutely stick with a GL-4 for the stock synchro box if you want to shift properly. Easy off the shelf solutions are Castrol Syntrans GL-4 75w-85 for box and Syntrax 80w-140 in both diffs, your crown wheel and pinions will last almost forever. Absolute Best in diffs is pretty much the Motul Comp gear 75w-140 for big power.

Also you didn't mention transfer case, pretty hard to be Castrol Transmax Z in that.

  • Like 1
Link to comment
https://www.sau.com.au/forums/topic/480010-r32-gt-r-oils/#findComment-7927012
Share on other sites

Million threads on it but Rotella t6 40 weight, is a great option for engine oil and is not super expensive.  And get the motul comp gear 75w140 fricken amazing shit your diffs will never be so happy. 

  • Like 1
Link to comment
https://www.sau.com.au/forums/topic/480010-r32-gt-r-oils/#findComment-7927292
Share on other sites

On 26/03/2020 at 3:45 PM, joshuaho96 said:

Rotella T6 is not recommended for high RPM engines due to the lack of anti-foaming additives. It works great on low RPM engines like diesels and low RPM gas engines like LS engines but the RBs rev high and tend to create a lot of oily air.

im gunna go ahead and say this is a load of malarkey mate....rotella t6 absolutely tried and tested I have this oil in over 15 units on my fleet as well as my integra type r, gtr, and gts. not to mention 2 1000hp supras in the area running t6. All cars that hit and see over 7500rpm daily.   never once have I ever seen "oily air"  or had any oil failures in anyway.  ive had good luck with motul but for what its worth the t6 is better bang for buck. redline oil caused my rb26 to burn oil and smell like fuel in oil, instantly changed back to t6 and my motor was happier than a pig in shit(never see oil in my turbo pipes either). come on don't add comments that aren't true at all its quite misleading. forget rpm its an oil that withstands higher compressions rates than any of our rb's. I change my oil every 2000km in the R and have never seen foamy or bubbly oil once and ive dropped it cold, mild, warm, hot, and screaming hot. Also, I check my oil often the dipstick is always thickly coated with t6 never seeing any bubbles or "airy foam"....cheers

  • Like 2
  • Haha 1
Link to comment
https://www.sau.com.au/forums/topic/480010-r32-gt-r-oils/#findComment-7927478
Share on other sites

its one thing to sift through a ton of info on these forums and believe everything you read, and its another to try, test, review, and find out what actually works for you and your cars.    

Link to comment
https://www.sau.com.au/forums/topic/480010-r32-gt-r-oils/#findComment-7927479
Share on other sites

On 3/27/2020 at 12:58 AM, MoMnDadGTR said:

Million threads on it but Rotella t6 40 weight, is a great option for engine oil and is not super expensive.  And get the motul comp gear 75w140 fricken amazing shit your diffs will never be so happy. 

Another vote for the comp 75W140 diff oil although if you have a super track car for a few extra dollars you can get the Nismo comp gear 75W140 diff oil (also made by Motul to a slightly higher spec). Expensive stuff but you only need a couple of litres.

  • Like 1
Link to comment
https://www.sau.com.au/forums/topic/480010-r32-gt-r-oils/#findComment-7927518
Share on other sites

On 3/29/2020 at 3:53 AM, MoMnDadGTR said:

im gunna go ahead and say this is a load of malarkey mate....rotella t6 absolutely tried and tested I have this oil in over 15 units on my fleet as well as my integra type r, gtr, and gts. not to mention 2 1000hp supras in the area running t6. All cars that hit and see over 7500rpm daily.   never once have I ever seen "oily air"  or had any oil failures in anyway.  ive had good luck with motul but for what its worth the t6 is better bang for buck. redline oil caused my rb26 to burn oil and smell like fuel in oil, instantly changed back to t6 and my motor was happier than a pig in shit(never see oil in my turbo pipes either). come on don't add comments that aren't true at all its quite misleading. forget rpm its an oil that withstands higher compressions rates than any of our rb's. I change my oil every 2000km in the R and have never seen foamy or bubbly oil once and ive dropped it cold, mild, warm, hot, and screaming hot. Also, I check my oil often the dipstick is always thickly coated with t6 never seeing any bubbles or "airy foam"....cheers

Foaming is created in dynamic conditions, you usually need high RPM to cause it. Low RPM conditions it shouldn't happen. Unless you have a viewing port in the crankcase you wouldn't know.

Personally I'm not a tribologist and I don't feel like gambling an engine on oil selection. There is a Rotella T6 that is dual rated. But I don't think it's wise to run an engine oil that is not rated for gasoline engines or only has bare minimum certs. Especially when you can find a lot of different oils that meet whatever spec you're looking for for any given engine. Maybe a dedicated diesel engine oil works great for you but it seems unwise to recommend that in general.

Link to comment
https://www.sau.com.au/forums/topic/480010-r32-gt-r-oils/#findComment-7927547
Share on other sites

this was only my 2 cents and also said motul 15w40 has my vote all day for the ballers. I was recommended t6 by a lot of guys on here that know a hell of a lot more than I do on this topic. not to mention running way more power than myself with crazy race setups.  if someone has used t6 with a bad review I would honestly like to see it. over 150,000 hard km between the 3 cars(probably more) all still on original engines and only one that has oil usage is the type r integra, go figure its a stock bottom end b18c5 that gets raped daily I hope it burns a bit. I wont recommend anything to anyone just saying what has worked for 100's of guys out there without issues. the only time ive ever seen this foaming your talking about is on diesel light plants that run 24/7 wide open in plus 40 conditions that get stopped for an oil change every 4 weeks....this tends to cause foaming yup I guess....(2500rpm low revving engine running spec t6 oil still foaming like crazy mate.)  foaming happens when an engine is being raped without proper cooling...add an oil cooler like every rb should have. t6 oil has lots of cleaning agencies in it you just need to change it more often if your worried...id take my rb26 to 7500km on t6 she loves it.

Link to comment
https://www.sau.com.au/forums/topic/480010-r32-gt-r-oils/#findComment-7927554
Share on other sites

2 hours ago, MoMnDadGTR said:

this was only my 2 cents and also said motul 15w40 has my vote all day for the ballers. I was recommended t6 by a lot of guys on here that know a hell of a lot more than I do on this topic. not to mention running way more power than myself with crazy race setups.  if someone has used t6 with a bad review I would honestly like to see it. over 150,000 hard km between the 3 cars(probably more) all still on original engines and only one that has oil usage is the type r integra, go figure its a stock bottom end b18c5 that gets raped daily I hope it burns a bit. I wont recommend anything to anyone just saying what has worked for 100's of guys out there without issues. the only time ive ever seen this foaming your talking about is on diesel light plants that run 24/7 wide open in plus 40 conditions that get stopped for an oil change every 4 weeks....this tends to cause foaming yup I guess....(2500rpm low revving engine running spec t6 oil still foaming like crazy mate.)  foaming happens when an engine is being raped without proper cooling...add an oil cooler like every rb should have. t6 oil has lots of cleaning agencies in it you just need to change it more often if your worried...id take my rb26 to 7500km on t6 she loves it.

Foaming in gasoline engines occurs when you do something like hard cornering and oil sloshes up the sides of the crankcase and gets whipped up by the crankshaft. Or the piston squirters in the OEM and Tomei RB26 pistons that cause oil to fall onto the crank that gets whipped up. Do this at 8000+ RPM and you will create some foam. Or overfill and the crank will start whipping up oil as soon as you turn the starter.

I'm always super, super skeptical of oil discussions because it's pretty much cargo cult stuff or straight up pyramid schemes in the case of Amsoil. But there is this post: 1764461059_ScreenShot2020-03-30at9_42_36PM.png.05d6a9c6b8112cca12ff1e391b8ce0a0.png

 

Whether there's any truth to this post is hard to say, but the source is here: 

 

Personally nothing I run is ever going to need more than whatever full synthetic is 5 USD/quart online or at a local store. I would probably be just fine with Rotella T6. But I would be very cautious of making that recommendation to all people for all things. 

Link to comment
https://www.sau.com.au/forums/topic/480010-r32-gt-r-oils/#findComment-7927567
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yes to both! Yes to standard ECU and tune, but exhaust is aftermarket. Unsure on brand. Actually have it sitting in at my desk haha! I have to set it up on my laptop but this is a great next step, will do. So I generally try to shift before 4.5K RPM most times. I largely don't do a lot of high-rev driving, but I will take it up to red 1-2x a week max, as I know the occasional "Italian tune-up" is good for these cars.  Oh wow, is this way better than what I'm getting. Does this mean there's a good chance I have an issue?   Thanks for all the info so far guys.
    • Old Son, did you re-use the Holden ABS in the new shell or try a different module?
    • Yeah, nah. I had the actuator rod off it today. The arm will not move at all. Neither out, nor in. Yeah, you'd think so, but I've been thinking about that. Even when the actuator rod fell all the way off at the beginning of this saga, it would build more boost and faster in lower gears than it would in higher gears, and you'd think that that was the opposite of what should happen. But I strongly suspect that there is a thing with the gearing getting the revs to rise faster, that there must be some transient effect with the gas flow rate rising quickly, that you don't get with the more steady state case of the higher gears. Keep in mind - the gate is not shut in either of my weirdnesses. So things are not "normal". We normally think about a turbo spooling up (below the wastegate target) with the gate shut. I have all sorts of mental models running now where the gate is a little bit open, and having it stuck open allowing gas out while it should be going through the turbine has all sorts of weird effects (in these mental models). I'm thinking in the higher gears, the ex mani pressure builds to the point where enough gases spill out the wastegate to just prevent the pressure rising much more at all, or just creeping up, all the whole the revs are increasing and getting closer to the point where a gear shift becomes necessary.
    • Is it possibly wastegate actuator itself is sticking, or even the rod to flapper? Otherwise I reckon things are getting a bit rusty/worn   Also odd it won't boost in 3rd to 5th, but will in 1st, I'd expect the other way around with it slightly open as there's more time on your way to redline for it to spin up
    • Does anyone know ow what these two plugs are for and if they should be unplugged? Just put the dash back together and can't remember if these were plugged in before or unplugged! (Blue and white plugs) 🤦🏽‍♂️
×
×
  • Create New...