Jump to content
SAU Community

Recommended Posts

just reading this other thread about how long people warm up their cars b4 they start driving...

i was wondering how long people leave their turbo timers for?

and also how did u by pass ur immobolizer or u just wait around?

i normally set mine on 15secs after normal driving around and about a minute if i gunned it : abit.

i got the Mongoose 3point alarm imobilizer which work in conjunction with my turbo timer.

Link to comment
https://www.sau.com.au/forums/topic/79152-how-long-u-cool-down-for/
Share on other sites

I look like a fool because i cant lock my car untill the engine shuts off. Im just hanging around my car for 30sec untill it turns off. I would use the Auto feature on my TT if i could lock the car and leave it. Auto normally does around 4 minutes...

15 minute warm up jesus you will be causing more wear on the engine then doing good i reckon. i normally let it warm up for a minute or two then just keep the rev's under 3K and try to keep off boost as much as possible till the oil preasure starts to drop down to the wamr level.

i warm my car up for 15min and leav turbo timer on for 5, neighbours get the shits but hey what can you do. my theory is if they complain smash their windows, if they call the cops get your mates to burn their car.

thats too ridiculous for words

anyway getting back to planet earth

as said before

dont drive hard for the first 5 or the last 5

my tt is always set for 10 seconds

i warm my car up for 15min and leav turbo timer on for 5, neighbours get the shits but hey what can you do. my theory is if they complain smash their windows, if they call the cops get your mates to burn their car.

That's ridiculous.

15 minutes is too long

5 minutes is too long

If they're windows or car was smashed they'd narrow it down to the knob who's car is always running with no-one in it.

15 minute warm up jesus you will be causing more wear on the engine then doing good i reckon. i normally let it warm up for a minute or two then just keep the rev's under 3K and try to keep off boost as much as possible till the oil preasure starts to drop down to the wamr level.

cool down here not warm up...

so most people wait around till their TT turn off before locking the car?

i agree with what others have said in terms of cool down really a turbo timer may not really be required if you just drive normally for the last 5 minutes or so. I have a turbo timer though for the times that i am in a bit of a rush its set to i think 30 - 40 seconds.

Its crazy to be running the car so hot up until you stop that you have to use a turbo timer at all. Its not just your engine, you need to think about brake temps warping rotors etc.

Just drive it slowly for the last 60 sec of your trip, lcok the car and wander off.

The only time a TT should be used is when you have just finished a session on a race track.

My car has done over 100,000km i dont have turbo timer and never let it cool down if ive been driving normally, if ive given it a hit then come to a stop (hardly ever happends) ill give it a couple of minutes. everything still seems to be fine! I agree just take it easy for the last minute or 2 of your drive.

So far just been taking it easy for the first 5 till the car warms up and the oil pressure evens out @ 2kg/cm^2.. than at the end I tend to take it early coming back into my place..

also - what's oil pressure meant to sit on.. i'm guessing about 2kg/cm^2 normal cruising, than when I boost for a bit heads up toward 4kg/cm..

anyways - yeah take it easy for the last couple of minutes.. + get a minute or so while I open the garage door..

tt's are dangerous in my opinion...

what are you guys going to do if someone t-bones your car at high speed, and your sitting there trapped in your car unconscious....hey the ignitions been killed, but the cars still pumping fuel....

I personally dont want to be burnt in my car, so i chose not to use one...same goes if you roll the car and the fuel lines are cut/broken.....pumps fuel out still.....

Just dont drive on full boost for the last couple of minutes of your trip and you won't really need to let it idle down.

If you run an oil cooled only turbo such as a TO4 or something then letting it idle/cool down is more critical.

The standard turbo's and most other modern turbos are watercooled, so excess cool down is simply not required.

My turbo timer hits a maximum of 3:20 using full auto mode and that's travelling long distance sustaining 110km/h+. Usually it will run for around the 1:30mark after some spirited, some normal. Mine's integrated into my alarm so i can lock the car with it running and walk away. No dramas.

tt's are dangerous in my opinion...

what are you guys going to do if someone t-bones your car at high speed, and your sitting there trapped in your car unconscious....hey the ignitions been killed, but the cars still pumping fuel....

I personally dont want to be burnt in my car, so i chose not to use one...same goes if you roll the car and the fuel lines are cut/broken.....pumps fuel out still.....

Thats why you hookup the handbrake sensor circuit.

That way if the handbrake isnt engaged and you turn the car off, the turbo timer doesnt operate.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hey all, It's been a bit since I have been able to update.  I pulled the fuel pump, first off it was a "universal" pump and the strainer was very clogged, and it was folded over on itself.  I replaced the fuel pump and all is well....  No more stalling.
    • That's convinced me I'll bump up the G30-660 to 770   Any idea if the difference in boost pressure? Cheers
    • When: Saturday 24th of May 2025 - All day Where: Sydney Dragway, Eastern Creek Cost: Varies - Book direct with the GTR Festival Website We will be there on the day with a stand please reach out via our interest form if you wish to help out with the stand. Limited parking will be available in the display area, first in first served with current members getting priority, please register your interest with the link above also. Please post any great photos you take on the day on this thread and we will try use some in our e-mails/website/social media
    • Hey guys so turns out this project is going to be much bigger than I thought haha but I've done some my homework and have done a few panels on my car, but one part I can just not visualise is this. If I do a spot repair and I put filler in a dent for example and sand outside of the repair with 320 grit lets say so the primer can stick as I will only put primer on that repair and the surrounding area and then repaint the whole panel. Don't I need to make sure that I don't put primer on the old clear coat? I keep seeing YouTube videos where people have new paint and primer land on the old clearcoat that isn't even dulled down, it's still shiny. I thought putting paint on clearcoat or primer on clearcoat is a bad idea because it won't stick. So in this scenario it's a bit different to mine but imagine someone doing a spot repair and only painting that small section of repair but the new paint is landing on the old clearcoat. What am I missing?
    • I was immediately reminded that your location is QLD. Sounds like a perfect SEQ business idea.
×
×
  • Create New...