Jump to content
SAU Community

Recommended Posts

what car, what mods, do you get black smoke? do you see any fuel coming out? what happens when you floor it? sounds like dead 02 sensor without knowing any more information

Hey guys, yeah its really wierd..

mods are 3" exhaust, 3" dump pipe and pod filter..

stock everything else... i took it in to get it looked at they tested it..

the O2 sensor was going nuts, but then he checked another R33 and wa doing the same thing.. i think they are going to change the spark plugs and dyno run it... see whats going on.

- Andrew

is there anyway to tell if the fuel reg is screwed without having to anoy a mechanic ?? any simple checks ?

could be a faulty fuel reg... but even then... i still had 200km's to a tank whe mine died

slap a pressure gauge on and go for a drive.

you'll soon workout if its working.

although, all you do is rev the car while its sitting there and if it belches some nice fuel cloud then its pretty certain.

Mine filled a workshop with fuel vapour/cloud after a good 5 revs. IT was a big cloud :)

I checked the pressure like 3 years ago when i shat one... the fuel cloud i knew from, but checked it anyhow as i was bored.

I cant remember what its meant to be

Are you saying it is using a lot of fuel by reading the gauge?

Cause the fuel level sender can come off its bracket pretty easy. I know mine has done it in the past.

Might be worth checking. Sometimes it is the simple things.

Adam

The TV show Top Gear reported getting 4 mpg in a Ford GT40 doing burnouts etc. on a race track. That is about 60L/100kms full throttle on a race track. If you can beat that whilst driving off boost, it can only mean a fuel leak somewhere. I cannot imagine fuel consumption THAT high just from poor tuning.

I was thinking huge injectors with PFC in japan and they replaced the

PFC with a stock computer to sell it but even then it would run like shit and not use that much fuel.

I would say you have a leaky injector/s, a hole in the pressurised supply side of the fuel system. or a V8 holden lives in your petrol tank :rolleyes:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...